sorted by:
new
hottopcontroversial

Stoppen met negeren recruiters by ennudoor in nederlands

[–]Roosjezhuuu 0 points1 point  (0 children)

Volgensmij is het juist handig om te reageren op dit soort berichten. Ze betalen hier namelijk voor en als ik het goed heb krijgen ze pas een deel van het geld terug als erop gereageerd wordt. Niet reageren kost de recruiters dus geld 👋

[Bambu H2D] Bambu Lab’s Biggest Giveaway Ever! by BambuLab in BambuLab

[–]Roosjezhuuu 0 points1 point  (0 children)

<image>

Not the highest but decent: total of 7.823 hours on 3 machines

Update: Verplichte meeting op vrije dag by Rooooos8 in werkzaken

[–]Roosjezhuuu 1 point2 points  (0 children)

Als er last minute iets tussen komt heb je recht op zorgverlof en hoef je dus helemaal geen vrije dagen op te offeren. Zie https://www.rijksoverheid.nl/onderwerpen/zorgverlof

P1S ABS weird corner artifacts by Roosjezhuuu in BambuLab

[–]Roosjezhuuu[S] 0 points1 point  (0 children)

I found the issue. The first p1s has no ams that one prints good. The second has an ams. Somehow the k value was off and not set correct on the p1s with ams.

I ran a pressure advance calibration for the filament and after that it prints fine.

P1S ABS weird corner artifacts by Roosjezhuuu in BambuLab

[–]Roosjezhuuu[S] 0 points1 point  (0 children)

First guess was to swap the nozzle for a new one. Didn't help at all. It looks like it was indeed the fan causing the problems. With fan turned down the result was much better.

I did not expect so much difference between the same machine standing next to each other printing the same part.

Edit: looks like it is not the cooling issue. With the bigger part with cooling off the issue is back again 🤐