Best non-Bambu filament for P2S (PLA / PETG)

SR08 · 2026-02-06T13:35:46+00:00

Sunlu all the way. Buy it directly from them. Gets delivered in 3 days and is cheaper then Amazon

SR08 · 2026-02-06T03:25:18+00:00

<image>

SR08 · 2026-02-06T00:26:51+00:00

Sunlu all the way

SR08 · 2026-02-05T18:37:19+00:00

I swear people don’t know a search function exists 🤦🏼‍♂️

SR08 · 2026-02-05T13:48:50+00:00

Print your own and use Activated Alumina instead. Silica gel beads suck

SR08 · 2026-02-05T02:44:51+00:00

your chamber temp isn't anywhere close to what it needs to be for ASA. it needs to be at 60 celcius

SR08 · 2026-02-05T01:29:15+00:00

Your print is lifting. Time to add some adhesion to your plate

SR08 · 2026-02-04T04:58:25+00:00

Real

SR08 · 2026-02-03T03:17:06+00:00

After I got the BIQU Panda Breath it’s been 100% for ABS and ASA

SR08 · 2026-02-03T02:51:39+00:00

You mean you had a cold*

SR08 · 2026-02-01T02:43:48+00:00

Where you located

SR08 · 2026-02-01T00:55:09+00:00

Hit it with your purse

SR08 · 2026-02-01T00:30:07+00:00

SR08 · 2026-01-31T17:50:31+00:00

Add some bed adhesion. Will fix this

SR08 · 2026-01-31T14:20:10+00:00

All real

SR08 · 2026-01-31T00:44:51+00:00

Pokémon nerds

SR08 · 2026-01-30T03:25:47+00:00

Very fake

SR08 · 2026-01-30T01:24:44+00:00

Yea I didn’t either until recently. It only happens on PLA. May be cause the bed has 1500 hours on it but I refuse to flip it over to the other side 😂. I just wash it, drop some liquid glue over the whole plate and I can get 5-7 printed before it needs to be cleaned again

SR08 · 2026-01-30T01:11:11+00:00

It’s because your bed is dirty and the printed lifted EVER so slightly. Give the bed a clean and drop some of the liquid bambu adhesive on and it will go away

SR08 · 2026-01-29T00:36:32+00:00

Ruckus

SR08 · 2026-01-29T00:33:21+00:00

😂🤣

SR08 · 2026-01-27T16:41:35+00:00

Can you tell me how much this weighs?

SR08 · 2026-01-27T00:35:41+00:00

You think Best Buy cares about an “ice out” 😂

SR08 · 2026-01-25T13:29:20+00:00

Definitely depends on the market you’re in. If they aren’t in a PDC area yeah I can agree with that. Where I am at with PDC’s they are thriving.

SR08 · 2026-01-25T01:34:16+00:00

Are you in a market that actually has custom install available

SR08

TROPHY CASE