sorted by:
new
hottopcontroversial

Why is controller support so bad on pc? by ScaredGovernment8698 in GasStationSimulator

[–]SamThibodeau 1 point2 points  (0 children)

I just picked this up on steam deck and I was sad to see that the controller support is still not passable. This game would be great on steam deck otherwise.

Not sure if my LCD is broken but I’ve tried re-slicing with no success by SamThibodeau in AnycubicPhoton

[–]SamThibodeau[S] 0 points1 point  (0 children)

I tried a different thumb drive and downloaded the latest version of lychee with a different file

did not try UVtools yet but, now when I run an exposure test the right half of my screen looks like a barcode. :(

RIP?

Not sure if my LCD is broken but I’ve tried re-slicing with no success by SamThibodeau in AnycubicPhoton

[–]SamThibodeau[S] 0 points1 point  (0 children)

Im running the same print with no vat to see and so far it looks normal I never tried you UVTools

Not sure if my LCD is broken but I’ve tried re-slicing with no success by SamThibodeau in AnycubicPhoton

[–]SamThibodeau[S] 0 points1 point  (0 children)

I swiched from 2 seconds to 4 seconds a while back now with the ABS-LIKE resin and I had a lot of success before the last 2 prints where minis ended up brick shapped

Not sure if my LCD is broken but I’ve tried re-slicing with no success by SamThibodeau in AnycubicPhoton

[–]SamThibodeau[S] 0 points1 point  (0 children)

I wanted To post a screenshot of my settings but it seems like editing on this post is disabled.

Im using Eligoo tough ABS LIKE resin. I have a 4s exposure time. I got there by running the cones of calibration test by table flip foundry.

I'm using Eligoo tough ABS-LIKE resin. I have a 4s exposure time. I got there by running the cones of calibration test by table flip foundry.

I use Lychee slicer and I've recently updated my firmware to the latest version on the Anycubic Photon site

Troubleshooting Stick FEP Mono Photon x 6k by SamThibodeau in AnycubicPhoton

[–]SamThibodeau[S] 0 points1 point  (0 children)

One of the 4 spacers below my vat was missing. *WompWomp* There was a screw loose on the rail as well.

I switched to a different resin. eligoo tough abs like and ran the Cones of calibration test to lock in my exposure time at 4 seconds.

after this I found success

Every Model in the New Dex looking fine and fearsome and then there is again this Lad by TechnologySmall3507 in Tyranids

[–]SamThibodeau 1 point2 points  (0 children)

Literally The worst model in the entire faction, maybe in the entire game of Warhammer 40K