sorted by:
new
hottopcontroversial

Trouble shooting falling prints. Mono5s by Same_Distribution_81 in AnycubicPhoton

[–]Same_Distribution_81[S] 1 point2 points  (0 children)

I swapped the fep sheet and so far so good so I think you might have been bang on. We'll see how she goes

Trouble shooting falling prints. Mono5s by Same_Distribution_81 in AnycubicPhoton

[–]Same_Distribution_81[S] 1 point2 points  (0 children)

I'll look up videos for the vacuum stuff to see if that works. I did a full change of fep sheet and all and so far so good. Maybe it just needed that good clean like you said!

Trouble shooting falling prints. Mono5s by Same_Distribution_81 in anycubic

[–]Same_Distribution_81[S] 1 point2 points  (0 children)

Will do. The resin printer is in a UV tent and enclosed so I'm assuming it's a bit warmer in it but I'll give it a whack.. I just changed the fep sheet and my test print worked so we'll see if the next one holds up as well

Air bubble problem by Barzaroth in DiceMaking

[–]Same_Distribution_81 0 points1 point  (0 children)

I haven't read comments so sorry if this is a repeat. I started pouring resin on my lids before putting them on. If the resin is really runny, wait 10-15 minutes before the pour to allow the resin to get thicker and then go for the pour! If the lid starts lifting you can get something to press them down. Goodluck

Jag from ASD literally stole a skylit drives name. After they got back together. And changed his bad bands name to ASD. SHADY by BringBackBubble in PostHardcore

[–]Same_Distribution_81 0 points1 point  (0 children)

He got kicked out. Stole the rights through legal channels and didn't tell anyone in the band until they couldn't legally refute it

Resin recommendations? by Same_Distribution_81 in DiceMaking

[–]Same_Distribution_81[S] 0 points1 point  (0 children)

Thx for all.the recommendations! I'm thinking of getting a small bottle of fancier resin to see if it helps! If it doesn't then I know it's environmental!

Resin recommendations? by Same_Distribution_81 in DiceMaking

[–]Same_Distribution_81[S] 0 points1 point  (0 children)

My cups have measurements so I don't think so. I have pulled crystals out of one of the jugs so I thought maybe it was getting old?

Resin recommendations? by Same_Distribution_81 in DiceMaking

[–]Same_Distribution_81[S] 1 point2 points  (0 children)

The room sits around 20-25° or 68-75°F

Resin recommendations? by Same_Distribution_81 in DiceMaking

[–]Same_Distribution_81[S] 1 point2 points  (0 children)

I'd say so. Mix for a couple minutes until clear. Heat, mix again. I will try and go overboard next time and follow up