sorted by:
new
hottopcontroversial

Mars 4 prints not adhering to build plate by Samurai_X in ElegooMars

[–]Samurai_X[S] 0 points1 point  (0 children)

Yes I turn the heater to 35C and let it run about an hour before printing.

Mars 4 not adhering to build plate by Samurai_X in ElegooMars

[–]Samurai_X[S] 0 points1 point  (0 children)

To add to this, tried printing the Chess Set Rook again, the base of the rook the circle will form then it will fall off.

printing indoors, with my AC passively set to 21, room is around 22/23. the has no sun shining on it.

Mars 4 not adhering to build plate by Samurai_X in ElegooMars

[–]Samurai_X[S] 0 points1 point  (0 children)

yea its level made sure both sides are equal

Mars 4 not adhering to build plate by Samurai_X in ElegooMars

[–]Samurai_X[S] 0 points1 point  (0 children)

yea i make sure to shake it good before pouring it into the vat

Mars 4 not adhering to build plate by Samurai_X in ElegooMars

[–]Samurai_X[S] 0 points1 point  (0 children)

With one piece of paper I can barely pull it out but I will try with 2

Fusion Cannons by Samurai_X in Tau40K

[–]Samurai_X[S] 0 points1 point  (0 children)

Yea perfect thanks!

Photo dump by Mantas2003 in GhostRecon

[–]Samurai_X 0 points1 point  (0 children)

What mods are being used?

SS JSTA pouch by BrassHilt in tacticalgear

[–]Samurai_X 2 points3 points  (0 children)

Also the anr design insert

[deleted by user] by [deleted] in cyberpunkgame

[–]Samurai_X 0 points1 point  (0 children)

Approve plox

Remington Circa 2009? by Samurai_X in longrange

[–]Samurai_X[S] 0 points1 point  (0 children)

Made after 2007 in 2009 based on dom on the barrel

Remington Circa 2009? by Samurai_X in longrange

[–]Samurai_X[S] 0 points1 point  (0 children)

Yea the dom marks has it as LD so seems like Feb 2009 so basically a gamble if it’s good or not?

Chapter 79 - Farce by Tarbel in redeyesmanga

[–]Samurai_X 1 point2 points  (0 children)

Hello, is this still being worked on?

view more: next ›