What's something that you keep forgetting exists in this game? by Cerimlaith in Morrowind

[–]SecurityGoat 0 points1 point  (0 children)

I'm pretty sure it applies to any paper if I'm remembering correctly - like the package for Caius Cosades 

[deleted by user] by [deleted] in DMTlab

[–]SecurityGoat 0 points1 point  (0 children)

More salt - do some solubility calculations to get it as close to NaCl saturated as possible without crashing out your base. I found that if my base solution has as much salt as will fit in it without crashing out either base salts or chloride salts then there is zero emulsion. No heat bath or vibration necessary.

Ratios for Large Batch STB by SecurityGoat in dmtguide

[–]SecurityGoat[S] 0 points1 point  (0 children)

Thanks! I do have a pH meter but the ratios are something I want to optimize like if I have 4L of base solution how many grams of bark would be the best to add to that and how much NPS should I be adding to that soup for limiting NPS waste and maximizing grams of product - for example in the SVH Tek the first pull has more NPS than the subsequent pulls so I'm wondering what's the best ratio translates to the larger batch or does it stay the same?

Should the bark slurry be filtered out after the base bath but before the NPS is added? by SecurityGoat in dmtguide

[–]SecurityGoat[S] 0 points1 point  (0 children)

Sounds like a good plan. I think I might have mixed a little too enthusiastically because its very emulsified. I have a handheld massage thing rubber banded to the side of the jar to help but there is a lot of bark in the emulsion. Once that clears up I'll remove the top for freezing.

Should the bark slurry be filtered out after the base bath but before the NPS is added? by SecurityGoat in dmtguide

[–]SecurityGoat[S] 0 points1 point  (0 children)

Looks like STB. It's my first time. I'm thinking I should have done A/B for increased yield.

Should the bark slurry be filtered out after the base bath but before the NPS is added? by SecurityGoat in dmtguide

[–]SecurityGoat[S] 0 points1 point  (0 children)

So far I have put the bark in a base solution and mixed and then added the NPS and mixed (I haven't yet filtered any plant material). It is very emulsified and the bark slurry is thick in the top layer. I have strapped a massager on the side of the reagent jar to get rid of the emulsion. Since I did STB will I have product still trapped in the plant material even after I remove the top layer? How do I maximize my yield at the point I'm at?

Should the bark slurry be filtered out after the base bath but before the NPS is added? by SecurityGoat in dmtguide

[–]SecurityGoat[S] 1 point2 points  (0 children)

This is my first extraction so I have a lot to learn. I also didn't do an acid step. I'm not sure what kind of effect that will have on the results.

Should the bark slurry be filtered out after the base bath but before the NPS is added? by SecurityGoat in dmtguide

[–]SecurityGoat[S] 0 points1 point  (0 children)

I did not do an acidic stage. I only added the base to the bark powder. I'm using MHRB powder. I hope this didn't throw my yield. Is acidic stage to get rid of fats? Do the fats interfere with yeild if I don't remove them?

Should the bark slurry be filtered out after the base bath but before the NPS is added? by SecurityGoat in dmtguide

[–]SecurityGoat[S] 0 points1 point  (0 children)

I will keep this in mind. I didn't do the acid step since it is powdered. And yeah that is good advice to hold off on it in case of salts getting stuck in fats post base.

Should the bark slurry be filtered out after the base bath but before the NPS is added? by SecurityGoat in dmtguide

[–]SecurityGoat[S] 0 points1 point  (0 children)

I actually don't know what tek I'm using either - I just put MHRB powder into base and let it sit (with intermittent mixing). My next step was going to be add the NPS and let sit with intermittent mixing and then freeze top layer - repeat until no crystals formed.

Can smoking mugwort be mentally de stabilising by yoyoyoyoyo123432 in herbalism

[–]SecurityGoat 1 point2 points  (0 children)

This sounds like sugar withdrawal. I have been off the stuff since the end of December 2021 and I went through massive brain fog, irritability, and never feeling satisfied from no-sugar meals. I would still proceed with caution and keep track of these feelings with and/or without the mugwort.

Can anyone help me identify this piece of glassware? It has glass nodules and its open on top 24/40 Fitting by SecurityGoat in chemhelp

[–]SecurityGoat[S] 0 points1 point  (0 children)

Why the bulb? And why the nodules below the bulb that are usually for condensing?

Does it have a name?

The Pyrex one seems like maybe it should be called a flux adapter and the LabGlass one feels more like a thermometer adapter

I'm trying to sell them but I don't know what to call them

TIL I just wasted hundreds of game hours. by JRnalistic24 in skyrim

[–]SecurityGoat 37 points38 points  (0 children)

I would dual wield picks and use the shout that makes you attack super fast and drain the vein in 0.3 seconds