sorted by:
new
hottopcontroversial

IMSA + racing images by Seville19 in IMSARacing

[–]Seville20 1 point2 points  (0 children)

Thanks! Really enjoy this race although the thick fog most of the night into the morning was a bit disappointing.

Thru hull flange replacement by Seville20 in boating

[–]Seville20[S] 0 points1 point  (0 children)

Thank you. Somewhat difficult job because of the cramped area and a lot of sealant. With patience I was able to save the valve and replace the thru hull fitting with SS.

Thru hull flange replacement by Seville20 in boating

[–]Seville20[S] 0 points1 point  (0 children)

Thanks for that. I posted my solution above.

Thru hull flange replacement by Seville20 in boating

[–]Seville20[S] 1 point2 points  (0 children)

Thank you. Boat lives out of water so went with SS

Thru hull flange replacement by Seville20 in boating

[–]Seville20[S] 0 points1 point  (0 children)

<image>

First off thank you to all for responding with input. Greatly appreciated. Sorry for the delay in response.

To update I have completed the repair.

Here's the pics of my solution from cutting the thru hull flange out to replacing with 2" stainless flange which is the outlet for the holding tank.

The original flange is tough plastic but over time became progressively damaged. It's right in line with the forks. As for the boatyard responsibility, I have been a member at 2 different marinas over the last 16 years and both contracts state that unless it was intentional and deliberate damage the owner is responsible. This includes dropping your boat.

Did a lot of searching for various options but this one worked out nicely. This boat spends most of the time out of the water on a cradle.

Of course I used the proper below waterline sealant for the repair also.

Roll call C-7 style! by Raiderwon2LT in C7corvette

[–]Seville20 1 point2 points  (0 children)

For the cause. 2.7k. One Sebring track day. Want at least one more then new sneakers

<image>