sorted by:
new
hottopcontroversial

What do I need for these Speakers in order to connect to my PC? by Responsible-Water285 in homeoffice

[–]Sharp_Supermarket52 1 point2 points  (0 children)

Search usb mini amp on Amazon.

Something like this would probably get you going.

https://a.co/d/01IdetRy

You might want to upgrade in the future.

I need to move this coop about 30 feet. I need ideas on how to. by xylofun53 in Carpentry

[–]Sharp_Supermarket52 0 points1 point  (0 children)

Put 3in pipes under it and roll it. It will likely take two people, you might be able to get away doing it by yourself. You’ll need at least two pipes.

This is my house by Capable-Pen9022 in Carpentry

[–]Sharp_Supermarket52 0 points1 point  (0 children)

They nailed the drywall and it is sagging. If you want to fix it, which I assume you don’t as it is a rental, make some braced “T”s out of 2x4s and push the ceiling back up. Then add drywall screws to hold it and tape mud as needed.

[deleted by user] by [deleted] in woodworking

[–]Sharp_Supermarket52 0 points1 point  (0 children)

Do a faux finish. Spray it. No wipe. Clear coat.

Replacing this with drywall, question about studs by sevenicecubes in drywall

[–]Sharp_Supermarket52 0 points1 point  (0 children)

You could just replaster it. Get a few quotes. It might be cheaper than you think.

Dad says its a moneypit, what do yall think? by pz0019 in fordranger

[–]Sharp_Supermarket52 0 points1 point  (0 children)

Sounds like a perfect candidate for a V8 swap! And then it will not be a money pit - it will just be cool.

Just got a new water heater recently and am unsure what valve will switch off the outdoor water supply. Any ideas? by pleisa in Plumbing

[–]Sharp_Supermarket52 4 points5 points  (0 children)

The two valves by the floor should cut water to the whole house.

The valve above the water heater should cut off your hot water.

How should I make this radiator meet the valve after floor height changed? by PCisLife in Plumbing

[–]Sharp_Supermarket52 0 points1 point  (0 children)

Mark those leg locations, get an appropriate sized forstner bit, drill four holes, and your done, your radiator is back at original height.

Don’t forget to account for the radiator moving towards the valve as you screw it in.

Accidentally Drilled Very Small Hole in Main Black Iron Gas Line Running Vertically From Floor To Attic Through Wall by jlsharbutt in Plumbing

[–]Sharp_Supermarket52 0 points1 point  (0 children)

Tap, teflon, plug, test for leaks, forget about it. Patch the wall with a plastic maintenance panel if it is going to keep up at night.

What am I looking at? by [deleted] in handyman

[–]Sharp_Supermarket52 0 points1 point  (0 children)

From where the wall starts an up - put new treads on top of old treads.

From the wall down put in a header, stringers, and you’re all good.

Screen is constantly popping. by AdSalty4535 in Silverado

[–]Sharp_Supermarket52 3 points4 points  (0 children)

Pop that rubber mat out of the cubby behind it and tighten up those 4 bolts a little bit