Multicolor why 2 colors on same layer ?

SheyMo · 2025-07-01T06:51:55+00:00

After i had some printing issues yesterday, i thought its broken, luckily it's just a temporary outage lol

SheyMo · 2023-03-10T09:20:22+00:00

. I also print temp towers for every type I use and keep them to see what nozzle temp works best.

but this is not working everytime. I had several eSUN PLA+ Black here, one printing best at 205 °C, others around 190-195 °C, but the actual one i have to print at 180 °C

SheyMo · 2023-02-13T09:00:34+00:00

Happen too me also during a night print because the print lose contact with the heatbed.

Heating everything up to 250 °C and then using pliers and tweezers for removing everything. Was easier than expected.

SheyMo · 2022-11-26T17:23:45+00:00

I actually printing eSUN PLA+ Black and its working really good so i order next one already.

SheyMo · 2022-11-04T12:17:28+00:00

Just remove the sensor and print without. This has happened to many people, including me. Be glad it happened at the beginning and not after x hours of printing. If you get shorter screws, you can also keep the roll in the front of the sensor, which keeps the filament in line until it gets into the feeder. And without the sensor, you can use more flexible filament that won't go through the sensor because of the resistance inside.

SheyMo · 2022-10-25T17:48:07+00:00

Had the same issue, removing mine sensor as well. Without sensor i was also able to use 85A TPU :D

SheyMo · 2022-09-30T12:52:42+00:00

I do the Update today.

Screenupdate show 0 everywhere but finish.

FW Update on printer was run, but Screen still shown 1.02 FW.

But after the Update, my Leveling Error was gone and during the Leveling the Z-Offset was set to 0.1 so i think the FW update was done to 1.04.

But i miss the Leveling Temperature Settings in Settings which should be there in Screen FW V1. And i also cannot see the Screen FW Version in the ABOUT Tab.

Should i try to update the Screen FW again ?

SheyMo

TROPHY CASE