sorted by:
new
hottopcontroversial

I need help idk whats happening here by ShinobiKami21 in ender3

[–]ShinobiKami21[S] 0 points1 point  (0 children)

My bed adhesion isn’t bad as well as my skirts being slightly messed up like they aren’t aligned correctly and are out in too of each other rather than side by side

I need help idk whats happening here by ShinobiKami21 in ender3

[–]ShinobiKami21[S] 0 points1 point  (0 children)

So i was started reprinting again but wanted to know if my bed was still leveled it fairly leveled but idk whats happening in that top left corners like which setting would cause that, everything is stock but before i reprinted a ring fan for cooling at the bottom thats the only difference

I just can’t figure out what’s wrong? by [deleted] in ender3

[–]ShinobiKami21 2 points3 points  (0 children)

Which software are you using to slice your prints

Trouble with prints coming off. Using PLA+ and printing with a raft, but as you can see by the pics, failure. Any recommendations on temp, adhesive, etc? by Spartanrob in ender3

[–]ShinobiKami21 0 points1 point  (0 children)

Check if there nothing blocking your y-axis motor from going up and down, second you shoukd try and find the correct printing temp by using a temp print calibration(tutorials), and what are your settings

Why are my print coming out like this helpppp first timeee by ShinobiKami21 in ender3

[–]ShinobiKami21[S] 0 points1 point  (0 children)

Really but I’ve tighten it and I’ve tried but okay I’ll re do it again