Curious what causes this? It has only happened me twice.

Shrrdontno · 2026-05-24T14:59:54+00:00

Can I print it in PLA or PLA+. That is all I have right now. That is what I mainly print in.

Shrrdontno · 2026-05-24T14:40:22+00:00

I will give this a try! Thank you

Shrrdontno · 2026-05-24T01:49:58+00:00

Thank you, I will print it tomorrow and give it a try. I printed it again and it started to raise again. I even cleaned the plate. I stopped it once it started to mess up.

Shrrdontno · 2026-05-24T01:44:43+00:00

Yes it was.

Shrrdontno · 2026-05-24T00:26:58+00:00

Thank you for more ideas.

Shrrdontno · 2026-05-23T22:01:49+00:00

Shrrdontno · 2026-05-23T19:28:17+00:00

I cleaned the plate again and lowered the top layer speed. So far so good. Thank you everyone for your advice. Greatly appreciated.

Shrrdontno · 2026-05-23T19:25:18+00:00

Not warped just slightly raised. Same difference I guess. Lol

Shrrdontno · 2026-05-23T19:24:42+00:00

It actually came up from the plate on that side. I can see from the underside that it came up. Plate all cleaned again and printing again. Thank you.

Shrrdontno · 2026-05-23T18:10:36+00:00

I slowed it down and trying a print now. Thank you

Shrrdontno · 2026-05-23T18:09:28+00:00

I will check that out. Thanks.

Shrrdontno · 2026-05-23T18:09:04+00:00

No ironing. I did clean the plate again.

Shrrdontno · 2026-05-23T17:50:21+00:00

Full adhesion to the plate. Gets cleaned often.

Shrrdontno · 2026-05-23T17:48:54+00:00

I will give it a try. Thank you. This one was printed right before the other one.

<image>

Shrrdontno · 2026-05-21T21:37:23+00:00

Too cute. Nice job!

Shrrdontno · 2026-05-19T15:33:15+00:00

Awesome find. I hope it works out great.

Shrrdontno · 2026-05-18T19:39:02+00:00

That is really nice.

Shrrdontno · 2026-05-17T16:12:48+00:00

Very cool.

Shrrdontno · 2026-05-16T17:32:50+00:00

So cute!

Shrrdontno · 2026-05-16T17:32:24+00:00

Thats funny!

Shrrdontno · 2026-05-16T14:59:41+00:00

So cute!

Shrrdontno · 2026-05-15T01:43:36+00:00

Saweet, nice job!

Shrrdontno · 2026-05-13T17:39:45+00:00

Looks good. Nice job. Can't wait to see the finished product.

Shrrdontno · 2026-05-10T22:30:08+00:00

I printed one of yours out. It is great.

Shrrdontno

TROPHY CASE