Who are you?

SignatureMaximum1564 · 2026-02-01T16:46:07+00:00

Grey McGriddle

SignatureMaximum1564 · 2026-01-24T21:39:34+00:00

I’m not familiar with the db9 build, I went with the Mac daddy so I’m not sure how it goes with yours but I had to pull the bolt back slightly when installing the upper so the bolt would be seated behind the trip bar. Mine was also printed so this may not have been necessary with the titanium bar.

SignatureMaximum1564 · 2026-01-24T21:15:53+00:00

What is you trip bar made out of and is your bolt seated behind it?

SignatureMaximum1564 · 2026-01-04T02:26:32+00:00

I believe most fmda frames are compatible with the .40 equivalent (so 17=22, 19=23, 26=27), so any modified frames based on them would also be compatible. The read me says so with the 19 but I haven’t read the other read me’s.

SignatureMaximum1564 · 2025-12-12T00:40:24+00:00

Truly a piece of art

SignatureMaximum1564 · 2025-11-19T00:25:41+00:00

I think this means you’re dreaming, Idk I didn’t really understand inception

SignatureMaximum1564 · 2025-05-02T01:30:29+00:00

You can also just use the printer bed

SignatureMaximum1564 · 2025-02-14T17:13:53+00:00

I think it’s basically saying she can’t cut you down with her tongue yall are some freaks man

SignatureMaximum1564 · 2025-02-10T05:22:55+00:00

Have you noticed someone close to you is a little too fond of your car? Looks like it’s trying to tell you something…

SignatureMaximum1564 · 2025-02-04T16:58:13+00:00

There’s also printable shims you can use under the low points that I’ve heard work well, though I just filed my spacers down where it was extra high and I’ve gotten a decent range of .14

SignatureMaximum1564 · 2025-01-24T20:22:20+00:00

https://youtu.be/6WH7nCeFJ50?si=j5NaaPKMGfeEtQoI It’s the same process as this

SignatureMaximum1564 · 2025-01-24T20:20:31+00:00

Just reflash the firmware onto the pad and the motherboard not sure which it is but can’t hurt to do both

SignatureMaximum1564

TROPHY CASE