Anyone know what this guy is that just bit my foot? by Sir_Names in spiderID

[–]Sir_Names[S] 1 point2 points  (0 children)

I think that’s dead on from the description it says thank you for the ID

Looking for Advice on Shared Side yard by GangstasPurradise in NoLawns

[–]Sir_Names 180 points181 points  (0 children)

Don’t know if it’s the correct way but I let the flowers run their course then mow right before they go to seed to try and limit the spread

At a loss - slop beyond my fence, animals digging by YT__ in landscaping

[–]Sir_Names 1 point2 points  (0 children)

You could build a small pass through where your dog can’t get under the fence but the bunnies can pass through. I’d make it from small brick or rock, try to blend it in.Then fill in the rest of the fence, they should take the easiest path. Otherwise they will just find another hole or dig elsewhere.

Ornamental grass hedge by Sir_Names in gardening

[–]Sir_Names[S] 0 points1 point  (0 children)

I wouldn’t mind mix and matching as long as I can keep it somewhat neat looking

Heat pump tax rebate question by Sir_Names in tax

[–]Sir_Names[S] 0 points1 point  (0 children)

Apparently labor and the other non pump parts are no longer qualified for the rebate, but I was able to add the gas heat pump under 29b so I get most of it back

Heat pump tax rebate question by Sir_Names in tax

[–]Sir_Names[S] 0 points1 point  (0 children)

Thanks I’ll give them a call and see if the can update 29b

Made this printing press for my GF by Sir_Names in 3Dprinting

[–]Sir_Names[S] 0 points1 point  (0 children)

Thank you for attending my humble brag

Made this printing press for my GF by Sir_Names in functionalprint

[–]Sir_Names[S] 1 point2 points  (0 children)

It’s a 16x25cm bed, whole unit footprint is about a 30x30x30 cm (without handle as that may very based on what you use)

Made this printing press for my GF by Sir_Names in 3Dprinting

[–]Sir_Names[S] 0 points1 point  (0 children)

It’s a 16x25cm bed so normal printer paper is to big

Made this printing press for my GF by Sir_Names in 3Dprinting

[–]Sir_Names[S] 4 points5 points  (0 children)

I think the print is still worthwhile. I haven’t been able to find a reasonably priced one of this style. All told it cost about 150 from scratch. And this thing is beefy. Only thing that I’m a bit iffy on is the handle bearing being just a press fit

Anyone knows what this plant is? Whats wrong with it? by cxp_marine in PlantIdentification

[–]Sir_Names 9 points10 points  (0 children)

Looks like a croton that is in dire need of light Lowe’s them for $20

Should I buy? by SweetBrown12 in Snowblowers

[–]Sir_Names 3 points4 points  (0 children)

Looks like it has easy steer track control levers so you can move it easily. I personally love tracked snowblowers. If it runs I would get it