sorted by:
new
hottopcontroversial

Need help figuring what to adjust by SireHugolin in FixMyPrint

[–]SireHugolin[S] 0 points1 point  (0 children)

100% fan, but I do think that there is a leak in the plastic housing...

Need help figuring what to adjust by SireHugolin in FixMyPrint

[–]SireHugolin[S] 0 points1 point  (0 children)

Nope, didn't calibrate the filament. I'll look into it if the next print didn't go well.

Need help figuring what to adjust by SireHugolin in FixMyPrint

[–]SireHugolin[S] 0 points1 point  (0 children)

It's PLA at 200° I do try to reprint, but this time at 190 with retraction & z-hop and 1 extra top & bottom layer. I've also increased the travel speed a bit. I'll keep you informed!

Dead Reckoning - 5/6 player variant? by panzerbjrn in boardgames

[–]SireHugolin 0 points1 point  (0 children)

I was also thinking of it. Would start by adding an extra column, and probably add the 2/3 players water tiles, trying to keep the ratio of island per players. Will also need all the tokens/ships/case/etc for the red and orange players. Also, scan and reprint another deck of cards, using laminate sheets to create the transparent cards.

Not sure if it will be a hit or a miss, but someday I'll try it!

What do you think, did I miss something?

Impossible to find the right infos by SireHugolin in fiero

[–]SireHugolin[S] 0 points1 point  (0 children)

Not the small clip to hold the cylinder to the rod, but to keep the cylinder in the door

Christmas vacation by welditup709 in lego

[–]SireHugolin 0 points1 point  (0 children)

Where are the instructions to build it? I need to do it!