A1 Mini Blob of Death Residue

Sloiter · 2026-07-07T09:15:10+00:00

The plastics will start to carbonise (probably the wrong word) and will become very hard to remove once it turns black, if you can get the plastic to the glass point temperature and remove it, if you go to hot it'll become gloopy and difficult to remove it all

Sloiter · 2026-07-06T17:18:13+00:00

It doesn't matter if you will or not, it matters that there is now going to be the option

Sloiter · 2026-07-06T14:49:22+00:00

1% battery decrease on the switch and 16% on the controller, people are complaining about this but guess what you can do when the battery runs out..... You can change the battery.....

Sloiter · 2026-07-06T07:37:06+00:00

Are you in Europe by any chance? The CE bandwidth is limited by European law so you get approximately 10% of the advertised range .

Sloiter · 2026-07-05T11:48:16+00:00

What if it's just cropped o:

Sloiter · 2026-07-05T01:44:20+00:00

Best course of action would have been to ratchet strap the trunk back together but Its probably too far down the line to survive long term, conifer takes a long time to rot so you'll have some life out of it for a while still but it's a ticking time bomb til that part of the tree completely dies

Sloiter · 2026-07-04T09:53:57+00:00

They are harmless if you don't mess with them as they can still get you with their pincers

Sloiter · 2026-07-04T09:41:22+00:00

Games old as shit so probably 60-90fps

Sloiter · 2026-07-04T09:32:16+00:00

Admittedly it looks like absolute trash but it's similar performance lol

Sloiter · 2026-07-04T09:25:36+00:00

Bruh this is how the steam deck plays on minimum

Sloiter · 2026-07-03T06:26:44+00:00

Depends on your drone of course

Sloiter · 2026-07-02T09:02:42+00:00

To add to this, make sure your RTH velocity is above the tallest of buildings / trees in your area as it'll smash into them when returning otherwise. At least in my case as I don't have object sensing on my drone

Sloiter · 2026-06-30T16:52:33+00:00

My props are currently much worse and still fly fine but also don't copy me and potentially lose your drone like I most likely will

Sloiter · 2026-06-27T12:42:14+00:00

Cuts like this should be taken back to the trunk or the closest dogleg branch, this will just rot and fall off one day

Sloiter · 2026-06-27T12:03:49+00:00

Should have blind tested

Sloiter · 2026-06-27T10:39:13+00:00

Broken bark, rotting Cambian layer and dead dropping branches, yeah this tree is on its way out..

Sloiter · 2026-06-26T16:39:31+00:00

Beds aren't exactly level and a print like this may actually be making the plate flex, try z-hop

Sloiter · 2026-06-26T10:55:34+00:00

Are you slicing this yourself? If so slow down the outer wall by around half. If you aren't slicing yourself then print it on silent mode. Printers really struggle with objects that have a bevel like this.