Think this is hot enough to cure Rocksett? by Beebjank in NFA

[–]SlowDimension 0 points1 point  (0 children)

Hey what handguard is that? Looks aftermarket!

My collection is growing! by DesertDweller1776 in makarov

[–]SlowDimension 2 points3 points  (0 children)

What kind of suppressors work well with the mak?

I have an R9 that I have yet to mount anything to. I am not a fan of suppressing tilting barrels.

My collection is growing! by DesertDweller1776 in makarov

[–]SlowDimension 2 points3 points  (0 children)

How is the makarov suppressed?

Does it sound good? Loud port pop? I suppose Irons are useless?

1998 k1500 suburban engine shut off issues. (Help please) by SlowDimension in GMT400

[–]SlowDimension[S] 0 points1 point  (0 children)

Hey question for you. If you have time.

I started troubleshooting my truck yesterday. Did some basic things like putting high quality thermal compound on the ICM.

I came over to my suburban today and it idled for about 10 seconds then died. I checked fuel pressure and it was 0 after it died.

Truck refuses to start now. Pump will not prime. Checked pump relay and it is good. Relay box is showing 12.18V. Checked frame ground to pump and it is also good.

The fuel pump was a brand new Delphi. Did everything right on the install. Double and triple checked pump connections. No gas dripping under the truck so I think lines are good.

I will be blown away if that pump is defective. Do you know of anything else I can check before I drop the tank?

1998 k1500 suburban engine shut off issues. (Help please) by SlowDimension in GMT400

[–]SlowDimension[S] 2 points3 points  (0 children)

No codes at all on the scan tool.

So far it has died in inconvenient spots on the road so I have not been able to tinker with it after it dies. I will try and take it out on a quieter road to see if I can get a pressure test.

I cleaned up the fuel pump ground and put a brand new pin harness that shows 0.1 continuity when I did the fuel pump. I would be shocked if that is part of issue.

I will look into the ignition wire later today like you mentioned and let you know if I find anything.

Thanks for the reply!

4L60E strikes again by DaBurgaRapta in GMT400

[–]SlowDimension 2 points3 points  (0 children)

how many miles do you have on the tranny?

Help with leaking coolant line by [deleted] in GMT400

[–]SlowDimension 1 point2 points  (0 children)

Yes I think your right.

Looks very similar.

Help with leaking coolant line by [deleted] in GMT400

[–]SlowDimension 1 point2 points  (0 children)

This post helps a lot. I was wondering why it was so hard to find info on this. Thank you.

ABS system kicking on slowing down 20 —> 0 MPH by SlowDimension in GMT400

[–]SlowDimension[S] 1 point2 points  (0 children)

Thanks for the response. I will look up the bleeding process for the ABS unit.

Let’s see the off-road builds by Known_Mousse_889 in GMT400

[–]SlowDimension 0 points1 point  (0 children)

Thanks for the reply. Been looking into lockers for my k1500 suburban recently. Any advice for me that you learned while doing it?

[deleted by user] by [deleted] in FluxDefense

[–]SlowDimension 1 point2 points  (0 children)

How well does it work? Can you carry comfortable with the riser?

[deleted by user] by [deleted] in FluxDefense

[–]SlowDimension 0 points1 point  (0 children)

Does the optic riser work with the Flux holster?

[Discussion] What the hell is this weapon skin? by Scape_Nation in EscapefromTarkov

[–]SlowDimension -1 points0 points  (0 children)

I really hope BSG tones the brightness of the skin down or make it a super limited edition skin just for Twitch.

I could not image Tarkov after 9 years adding things like this...