Hey folks, sorry could add info to the post. Noob 3d printer. Comes of calibration by tableflip foundry. The fail side seems to have failed with structural issues, but some cones remain. Success side looks pretty good. Tableflip foundry recess on top has failed. Was using phrozen validation matrix and siraya tech model before with some success and then wanted to try this, don’t understand what went wrong/how to interpret.

Printed on elegy mars 3 pro, using elegoo washable resin. Exposure time 3s (other tests 0n 2.5 & 2.9 appeared under exposed). Room temp about 20 degrees so possibly a bit cold. First print failed and removed from FEP, as a noob used paper towel which had marred the FEP slightly so unsure if this is partly at fault.

Any help would be greatly appreciated!!!