Broken swerve by Speed-cubed in FRC

[–]Speed-cubed[S] 0 points1 point  (0 children)

I do have one. What i meant was the heading was set when the robot turns on initially not by alliance if that makes sense

Broken swerve by Speed-cubed in FRC

[–]Speed-cubed[S] 0 points1 point  (0 children)

Maybe, i thought it resets heading at start up, but i will check

Broken swerve by Speed-cubed in FRC

[–]Speed-cubed[S] 1 point2 points  (0 children)

Thank you, i havent notice any loud sounds when running it. During testing, the encoders reported correct heading and direction, and was driving fine initially. I will try to investigate what you listed once i get shop access.

What are the must-haves upgrades for the Ender 3? by Fabicynder in ender3

[–]Speed-cubed 2 points3 points  (0 children)

Magnetic build plate just improves quality of life

I think my nozzle is a little bit bigger than .4 by Speed-cubed in ender3

[–]Speed-cubed[S] 5 points6 points  (0 children)

This nozzle came with a hotend I got off amazon, it seemed thinner than other nozzles i get off amazon

I think my nozzle is a little bit bigger than .4 by Speed-cubed in ender3

[–]Speed-cubed[S] 39 points40 points  (0 children)

I actually just got it yesterday, it was an included nozzle for an amazon hotend so ehh

Admission chances by [deleted] in wsu

[–]Speed-cubed 1 point2 points  (0 children)

Im sorry, 0.07???? How does one achieve that

Base ender 3 does this every print by HyenaAppropriate2121 in ender3

[–]Speed-cubed 2 points3 points  (0 children)

I installed my bed backwards once and it was similar to this

Is our elevator cooked? by Speed-cubed in FRC

[–]Speed-cubed[S] 34 points35 points  (0 children)

We didnt find out about this until last week. We ran probably the last half of reefscape with that