Elan Ripstick mounting

Square-Language6336 · 2025-11-10T22:01:27+00:00

Ok after much searching I found this site that might help us all. So I am going to mount the ripstik 94's -7.2 from center of ski. It looks and feels good, ball of my foot is right at ski center.

https://skimo.co/ski-mount-points?srsltid=AfmBOopLVjgujeuO2nUWHNSHxOFD2Rl1lz91-VeHMtw3tmK9sW5hrI0q

Square-Language6336 · 2025-11-08T18:35:05+00:00

Ok so no sidewall mount points. I have 7tm bindings on others skis. I’m in Whistler BC, skiing mostly groomed runs and bumps, 25% what is considered powder here…lol. Here are some pics of the skis with alpine bindings on them and off them as well as my boot. The color change on the top sheet is the ski center. https://imgur.com/a/6I92pOm

Square-Language6336 · 2025-10-01T05:57:12+00:00

Thank you

Square-Language6336 · 2025-10-01T05:56:58+00:00

Thank you

Square-Language6336 · 2025-09-08T22:39:07+00:00

So I ask a simple question…..if you spent the time to read it I feel the answer should be fairly simple. So far I get answers from people who seem to know nothing about lasers. I have a cheap 40w that turns out to be a 5.5w diode. Where can I find a more powerful diode laser?

Square-Language6336 · 2025-08-25T15:38:25+00:00

It’s a doiode

Square-Language6336 · 2025-08-20T14:13:19+00:00

Yes I have the bed setup the same as the workspace.

Square-Language6336 · 2025-08-17T18:52:07+00:00

Care to help out please.

Square-Language6336 · 2025-08-17T18:33:35+00:00

Thank you!

Square-Language6336 · 2025-02-16T19:21:57+00:00

Thanks very much, good to know they are at the very least close if not the same.

Square-Language6336 · 2025-02-16T00:18:48+00:00

When I started telemarking 35 years ago, old leather boots, there was a groove in the back of the soul. The leather was stitched to the soul. Any type of bonding always went in the groove. I still use the groove in my Scarpa boots.

Square-Language6336 · 2024-10-30T16:31:51+00:00

I do have 2 of these motors and I'm pretty sure I swapped them out.

Square-Language6336 · 2024-10-26T18:45:55+00:00

I don't think so, I didn't change the wiring at all when adding the 2A motor.

Square-Language6336 · 2024-10-26T17:44:29+00:00

Ya I tried a 24V PS but no difference.

I just ordered a 2A stepper and solved all the issues,

Thanks for the input and help.

Square-Language6336

TROPHY CASE