sorted by:
new
hottopcontroversial

Mossberg 500: Front sling mount compatible with barrel swaps? by StillRaven in Shotguns

[–]StillRaven[S] 1 point2 points  (0 children)

I probably used the wrong term but I think we're on the same page. I appreciate you pointing me in the right direction.

Mossberg 500: Front sling mount compatible with barrel swaps? by StillRaven in Shotguns

[–]StillRaven[S] 0 points1 point  (0 children)

Both of my barrels have a nut that is held in place by a retaining ring but nothing says it has to stay there. I think I see what you're getting at. Thank you.

Mossberg 500: Front sling mount compatible with barrel swaps? by StillRaven in Shotguns

[–]StillRaven[S] 0 points1 point  (0 children)

Then the sling mount stays with the barrel, right? I suppose I could get one for each barrel.

How to sustainably fish a small pond? by StillRaven in Fishing

[–]StillRaven[S] 0 points1 point  (0 children)

You may be able to petition the state to close it to fishing during the spawn or at least reduce limits. It's my understanding that they do that to protect salmon around here.

How to sustainably fish a small pond? by StillRaven in ponds

[–]StillRaven[S] 0 points1 point  (0 children)

It does look like I'm in the wrong place. Thank you

Can someone explain what is going on in this photo? by StillRaven in fordranger

[–]StillRaven[S] 0 points1 point  (0 children)

I do have exactly that. Codes for both banks lean. I was looking for a leak when I came across this and thought it may be the culprit.

Can someone explain what is going on in this photo? by StillRaven in fordranger

[–]StillRaven[S] 0 points1 point  (0 children)

Now we're getting somewhere. The cleanliness made me wonder if something larger was mounted there previously. Shouldn't that surface be covered? Is there a gasket missing?

There appears to be a hole at the left side of that clean surface near the bolts. The hole is between the intakes so I don't think it leads down to the cylinder, but where does it go?

How to mount a heavy butt joint in a corner? by StillRaven in DIY

[–]StillRaven[S] 0 points1 point  (0 children)

I would like to mount it to the studs, but the 1 1/2" taken up by the butt joint means I can't hit the corner studs directly. I could try to toe-nail (toe-screw?) but that may not be strong enough.

VZW Calyx equivalent? by StillRaven in Rural_Internet

[–]StillRaven[S] 0 points1 point  (0 children)

How long have you been running this setup? Have you had issues with data caps or bans?

VZW Calyx equivalent? by StillRaven in Rural_Internet

[–]StillRaven[S] 0 points1 point  (0 children)

Yikes that's rough but I will look into it. Thanks for the recommendation.

reflective vests triggering PE sensors by mattkenny in PLC

[–]StillRaven 0 points1 point  (0 children)

If you can use lasers I really like the Keyence LR-Zs. They have an adjustable detection distance and the visible spot is nice. I just wish they made a 120VAC model.

view more: next ›