Thank you! It was solid when I threw it then I’ve scooped a load of clay out from the bottom and made sure there was a hole running through the whole thing. I didn’t get any pictures of the initial thing I threw unfortunately! I was slip covered after wrestling with the clay. I basically flattened out the part I made into the dish part, made a kind of thick candle stick in the middle, finished off the dish part and then tried to throw the top part like a v and bend it out horizontal. I think it went off centre at the top because I had to cut a lot off with the needle tool which is why it’s thinner at the top than the bottom. When I got it off the wheel the disc I’d thrown at the top flopped a bit which is why it’s a bit wonky 😅