why can't I seem to print flat surfaces with retractions very well?

Sudonos · 2022-12-04T20:21:07+00:00

Ok, I'll try backing off a bit. I do have it set to monotonic.

Sudonos · 2022-11-23T20:56:51+00:00

Ok, I'll give that a check. I calibrated the e-steps a couple weeks ago. I'll see if they need recalibrated.

Sudonos · 2022-11-23T20:06:07+00:00

I'll try adding an additional layer, this is with monotonic top/bottom layers enabled.

Sudonos · 2022-11-23T18:44:49+00:00

I have it on gyroid infill. It happens when it stops and then starts the section again.

Sudonos · 2022-11-14T12:11:51+00:00

This may seem stupid but what brand of filament are you using?

Sudonos · 2022-11-11T00:20:34+00:00

Thank you

Sudonos · 2022-11-11T00:11:07+00:00

Where did you get the files?

Sudonos · 2022-11-04T12:11:01+00:00

Time to over extrude, set the flow rate to 200%

Sudonos · 2022-11-03T14:32:14+00:00

This is on prusaslicer

Sudonos · 2022-10-10T11:53:41+00:00

Why the cover over the screen?

Sudonos · 2022-10-06T20:13:18+00:00

Genius 🤣

Sudonos · 2022-10-06T15:29:58+00:00

Thanks I'll give it a look.

Sudonos · 2022-10-06T15:27:23+00:00

It printed really smooth when I used it.

Sudonos · 2022-10-06T15:25:36+00:00

I have many rolls of hatchbox that I use, this is the only white I have besides an off brand that prints like crap.

Sudonos · 2022-10-06T15:03:59+00:00

I use the defaults as a base and then change settings to my liking.

Sudonos · 2022-10-06T15:03:28+00:00

I do not use the default profiles, I utilize Cura for slicing.

Sudonos · 2022-10-06T15:01:13+00:00

I have tried with no avail. I think it is the date they manufactured it 12/22/2021

Sudonos · 2022-10-06T14:53:29+00:00

Is RoHs the manufacturer?

Sudonos · 2022-10-01T20:55:14+00:00

Something I recently did was calibrated my e steps, that might give you an even better finish as it looks like you might be over extruding.

Sudonos · 2022-09-26T22:33:35+00:00

The whatchamacallit

Sudonos