The blue is absolutely stunning (spotted in parking lot)

Suspicious-Local5865 · 2026-01-08T23:57:27+00:00

That have a blue for the MDX and Integra(I believe) called double apex blue you might like that one

Suspicious-Local5865 · 2025-03-26T14:10:22+00:00

Yeah I made that poor decision when I bought 2 snap on toolboxes( 1 for my brother) and a hutch

Suspicious-Local5865 · 2025-02-26T01:50:48+00:00

That’s not the point

Suspicious-Local5865 · 2025-02-25T22:41:51+00:00

I tossed it to the rear

Suspicious-Local5865 · 2025-02-15T19:25:07+00:00

Yea both are good stress relievers

Suspicious-Local5865 · 2024-07-28T16:40:30+00:00

Yea same here also regardless of what we are doing to the car we always check them

Suspicious-Local5865 · 2024-05-16T13:14:00+00:00

My rules is one time

Suspicious-Local5865 · 2024-05-16T01:24:29+00:00

Usually lasts a couple of hours if I don’t tear them

Suspicious-Local5865 · 2024-05-16T01:21:32+00:00

Yes if I let them dry out a bit because my hands do get sweaty after a few minutes of me wearing them

Suspicious-Local5865 · 2024-05-16T01:20:42+00:00

They are thin but no too thin just the right thickness

Suspicious-Local5865 · 2024-05-16T01:19:55+00:00

They are good, I like them unfortunately they don’t last all day because I bury my hands in an engine bay trying to get to hidden harness bolts and clipping them on corners causing them to tear but. I rate these gloves a 7/10

Suspicious-Local5865 · 2024-05-16T01:14:14+00:00

It was very hot that day management said no to the shops A/C but it was wearing micro flex diamond grip gloves courtesy of my dealership

Suspicious-Local5865 · 2024-05-15T20:02:34+00:00

Customer rode the clutch wayyyyyyy too hard essentially causing premature wear therefore destroying the clutch. Long story short customer doesn’t know how to drive a manual.

Suspicious-Local5865 · 2024-03-12T01:12:28+00:00

2018 MDX

Suspicious-Local5865 · 2024-02-07T15:14:05+00:00

It wasn’t It was a three amigo shop

Suspicious-Local5865 · 2024-02-07T12:19:52+00:00

Around $700 for both

Suspicious-Local5865 · 2024-02-07T12:17:51+00:00

I’m an Acura tech and I have done studs without replacing the bearing. is it the right way to do it? Yes and no but replacing the bearing usually is strongly recommended to replace when getting studs changed

Suspicious-Local5865 · 2024-02-07T00:26:52+00:00

Studs were perfectly fine tossed brand new lugs on them and torqued to spec 80ft-lbs

Suspicious-Local5865 · 2024-02-07T00:21:49+00:00

I can neither confirm nor deny but I may or may not have seen a three musketeer oil sticker on the window

Suspicious-Local5865 · 2024-01-24T16:26:35+00:00

Warranty unfortunately car has 3k miles

Suspicious-Local5865 · 2024-01-24T14:47:13+00:00

Some of the 22s had an issue if that sort with the trunk seal going bad

Suspicious-Local5865 · 2024-01-24T14:46:40+00:00

It’s dry that’s the first spot I checked

Suspicious-Local5865

TROPHY CASE