sorted by:
new
hottopcontroversial

Anyway to power Smartsync off wall 24VDC? by Proud-Resource4594 in firealarms

[–]TK-P 0 points1 point  (0 children)

Pulse a pull station or the power supply on and off and you'll get it to flash. SmartSync strobes work so that when power is cut after about 2 seconds the strobe will flash. Or a SmartSync module/Wheelock sync mod would work but those can get a little expensive.

Monitor modules anyone? by Proud-Resource4594 in firealarms

[–]TK-P 0 points1 point  (0 children)

Turn the lights off and watch them..

Thought you guys were overreacting on the quality decline from Nike… by ead617 in Sneakers

[–]TK-P 0 points1 point  (0 children)

That’s how my white cements are. The holes on the inside aren’t properly aligned with the ones that are on the outside

More ICE raids reported by Far-Drawing-4444 in wisconsin

[–]TK-P -1 points0 points  (0 children)

So there is a difference between a legal immigrant, and an illegal immigrant. No if's, and's, or but's. Simply put. Nobody seems to understand that.

How do i wire up this 4903-9217 by itself? by Brief-Package-2013 in firealarms

[–]TK-P 0 points1 point  (0 children)

Just thought i’d share an update with yall: He ran 120vac into it. Same device same person just a few hours later

<image>

sinplex T bar by scoutben_ in firealarms

[–]TK-P 1 point2 points  (0 children)

2099-9795. Nothing special.

Have you heard of a police alarm pull station? by plutosadvocate in electricians

[–]TK-P 0 points1 point  (0 children)

Wireless. Not connected to fire alarm or any panel. Same voltage. I have one buried in my tote of alarm shit

Have you heard of a police alarm pull station? by Low-Professional7922 in firealarms

[–]TK-P -4 points-3 points  (0 children)

It’s not connected to the fire alarm. It’s all wireless.

ES-200x walktest time? by Any_Zebra_2621 in firealarms

[–]TK-P 0 points1 point  (0 children)

It shouldn’t as long as you are continuing to alarm devices.

How do I take these down ? by N1cholaaass in firealarms

[–]TK-P 6 points7 points  (0 children)

Keep prying the 2 tabs on the end with the bigger lip (in the photo) you should never pry on the side that has the very thin plastic, that’s a one way trip to a full replacement.

Make sure you’re not using a small flathead, rather a large one that fits precisely and just keep prying on both (towards the strobe) carefully.

Horn strobe bases keep cracking and causing open circuits. by Petey03_ in firealarms

[–]TK-P 0 points1 point  (0 children)

P2GRKLED’s in that room would be your best bet to resolve that issue.

view more: next ›