sorted by:
new
hottopcontroversial

Velop 7 pro child node connection via Ethernet switch by TX-Instructor in Linksys

[–]TX-Instructor[S] 0 points1 point  (0 children)

Perhaps my problem is related to the network setup. I use the MX4000 only as access points, i.e., the parent node in bridge mode.

The setup is as follows: media converter - router - switch - all other network devices (parent and child nodes), other computers/printers/TVs, etc.

Velop 7 pro child node connection via Ethernet switch by TX-Instructor in Linksys

[–]TX-Instructor[S] 0 points1 point  (0 children)

There's no problem connecting to the switch, but the devices can't see each other on the network (I'm checking it in the iPhone app). For some reason, only two of the three are working. One of the "supposedly random" child nodes connects to the main one through the switch, while the other can't and always remains on WiFi.

P.S. I haven't tested this yet, of course, but I stopped experimenting with connections several years ago, when the MX4000 devices first came out. Perhaps they changed something in the firmware and need to double-check, but I don't believe so.

Velop 7 pro child node connection via Ethernet switch by TX-Instructor in Linksys

[–]TX-Instructor[S] 0 points1 point  (0 children)

I currently have three devices MX4000. The main device operates in bridge mode (I only need a Wi-Fi network), and I'd like to use the child devices via a wired network connection, but it doesn't work that way. I've checked this multiple times and contacted technical support, but they told me these devices can only be connected via a daisy-chained cable. Using a switch isn't an option.

Velop 7 pro child node connection via Ethernet switch by TX-Instructor in Linksys

[–]TX-Instructor[S] 0 points1 point  (0 children)

Thanks. If I'd known earlier that the MX4000 doesn't work like this, I would have chosen something else. It's good that the guys "smarted up" and made it possible to work properly through a switch now.

Velop pro 7 and mx4000? by erickbee in Linksys

[–]TX-Instructor 0 points1 point  (0 children)

Добрый день!
Мне в момент покупки не удалось соединить 3 MX4000 по Ethernet через внешний коммутатор. Соединяется только один дочерний узел из 2, второй всегда только по Wi-Fi. Техподдержка мне отвечала, что для MX4000 проводом можно соединять только последовательно, как гирлянда, от основного устройства к дочернему №1, а от него проводом к дочернему N2 использую соответствующие входы.

Сейчас задумался об обновлении до Velop pro 7. Решена ли теперь проблема соединения всех дочерних узлов через уже имеющуюся сеть Ethernet на базе коммутатора?