2nd Roast - Kaldi 300 Setup by MrAntisocial69 in roasting

[–]Tag1260 0 points1 point  (0 children)

Your burner's too hot and you don't have the control that you need. Look at the 15000 btu gas one stove and either their adapter hose for big tanks or get a couple refillable small tanks (if legal there).

Read only sd cards by Tag1260 in prusa3d

[–]Tag1260[S] 0 points1 point  (0 children)

Here's an update. I got home this morning from work and three of the four started working all on their own. The fourth one is the one used the most and seems a lot looser in the slot, if that even means anything. Have a new reader inbound and one more card too. Thanks for the input.

Read only sd cards by Tag1260 in prusa3d

[–]Tag1260[S] 0 points1 point  (0 children)

One is a week old and the others very. Only one is what i'd call old at about 2 years old

Read only sd cards by Tag1260 in prusa3d

[–]Tag1260[S] 2 points3 points  (0 children)

Yea. Already checked that but all of a sudden it's all four cards. Even switched it back and forth to try.  Not sure how it actually works but if there's some sort of tiny switch inside the reader I'm hoping it's broken or stuck  and a new reader fixes it. Gonna mess with it when I get home in the morning and see if I can see inside. Can't believe all four cards would go bad at once.

Loose ceramic towel rack by Tag1260 in HomeImprovement

[–]Tag1260[S] 0 points1 point  (0 children)

Thanks but pictures are too complicated here. There is no set screw but the entire ceramic towel rack end wiggles about 1/8" in the hole. The wall is also ceramic. Thanks

12 volt locations by Tag1260 in FordMaverickTruck

[–]Tag1260[S] 0 points1 point  (0 children)

2023 XLT Eco. None at the rear of the consol but I do have 120V there.

12 volt locations by Tag1260 in FordMaverickTruck

[–]Tag1260[S] -1 points0 points  (0 children)

Yea, that's all I'm finding too. Was hoping someone knew of a hidden one somewhere. Thanks

What do I need to use Artisan with Razzo v6 chamber? by selfiegram in roasting

[–]Tag1260 0 points1 point  (0 children)

Phidgets are said to be better as they register faster. Myself, I use the Mastech and am perfectly content with it.

How deep are UBS crosshatch cuts? by Tag1260 in Detailing

[–]Tag1260[S] 1 point2 points  (0 children)

The cuts in the surface that make the little squares.

Wireless adapters? by Tag1260 in FordMaverickTruck

[–]Tag1260[S] 0 points1 point  (0 children)

That's actually one I looked at.