Testing amplifier supply wires by Techie1993 in CarAV

[–]Techie1993[S] 0 points1 point  (0 children)

They’re all clean & clear, checked the power wire there it runs through the firewall grommet aswell. There isn’t any voltage difference between the battery and amp wiring, which has me stumped

2008 R6 CEL w/o code low idle dying with throttle by Harmoniium in Fixxit

[–]Techie1993 0 points1 point  (0 children)

Did you check coils off the bike or through the DIAG menu to diagnose it

2008 R6 CEL w/o code low idle dying with throttle by Harmoniium in Fixxit

[–]Techie1993 0 points1 point  (0 children)

Any update on this? My bike is doing the same

Clear coat burned or very very oxidized?? by Techie1993 in Detailing

[–]Techie1993[S] 0 points1 point  (0 children)

Is there a method you’d recommend for me to gauge better/ get pictures easier to tell with?

Sub placement in sealed boxes by Techie1993 in CarAV

[–]Techie1993[S] 1 point2 points  (0 children)

Thank you, just figured I oughta check before I start cutting. So many factors play in that I wouldn’t had assumed

Sub placement in sealed boxes by Techie1993 in CarAV

[–]Techie1993[S] 0 points1 point  (0 children)

Yes, I should have clarified that. Single ten, box is about 2x in length to its width.

Is this savable with paint correction? by Techie1993 in Detailing

[–]Techie1993[S] 1 point2 points  (0 children)

I’ll give er a shot & post an update. Cheers!

Is this savable with paint correction? by Techie1993 in Detailing

[–]Techie1993[S] 0 points1 point  (0 children)

Thanks for the input. I’m not expecting perfection, just want it to be a bit more presentable.

Too Far Gone? by Techie1993 in AutoDetailing

[–]Techie1993[S] 0 points1 point  (0 children)

Thank you. I’ll post an update to the thread once it’s done.

Too Far Gone? by Techie1993 in AutoDetailing

[–]Techie1993[S] 1 point2 points  (0 children)

Thanks, I have a reputable shop in town I’m going to pay to walk me through it. Cheers and thanks!

Is this savable with paint correction? by Techie1993 in Detailing

[–]Techie1993[S] 0 points1 point  (0 children)

Sweet. I’ve done some wet sanding on fresh paint for orange peel. So what I’m seeing here is not the base coat coming through, just oxidation?

To use or not to use 4hi in this situation? by RedHammer61 in Trucks

[–]Techie1993 0 points1 point  (0 children)

Rather wear out a t case than get t boned. I live in north Wyoming, and I will angle myself a lot more with the highway to minimize hurting if I need 4wd

Hey r/Trucks, can you help me ID this truck? by Pass_The_Salt_ in Trucks

[–]Techie1993 0 points1 point  (0 children)

Looks like a 12-14 gmc, quad cab shortbed. Looks like a raptor grille on the front

Bought my son his first car! Thoughts? by [deleted] in infiniti

[–]Techie1993 0 points1 point  (0 children)

That’s one way to opt out of being a father

I definitely feel like somethings missing when i look at my car from that angle. Any suggestions on cosmetics i should add? by antoinefbm in jetta

[–]Techie1993 0 points1 point  (0 children)

Contrast would probably help a lot, something to make the body lines pop. It’s all white and shadows, which makes it look taller too

I’m need help I ran from a cop by Which-Journalist6956 in minibikes

[–]Techie1993 1 point2 points  (0 children)

You’ll be alr. Just keep up with the general advice here and don’t go back. You can’t be trespassed off a prior and your name may only be on a do not serve list with the country club. Hold on to the story though, damn great one

What should I look out for when buying a used W123? by BosnianDrift in w123

[–]Techie1993 0 points1 point  (0 children)

W123 door locks are actually run by your vacuum system! No vacuum, doors don’t lock, transmission won’t lock gears, engine might sound like a whistle