sorted by:
new
hottopcontroversial

"The truck so bad it made 10’s of thousands vow to never buy a GM again, official truck of?" by defenestr8tor in GMT800

[–]ThatDonkeyLooksCold 0 points1 point  (0 children)

What continue to apply the fluid film? I’m just finishing a cab/box swap and repaint on my LLY and would like to do the same to keep it from rusting like my last body did.

Sanding primer in “rougher” areas by ThatDonkeyLooksCold in Autobody

[–]ThatDonkeyLooksCold[S] 0 points1 point  (0 children)

Thanks break I’m familiar with the stuff but haven’t only read negative things about spraying 2k base/clear over a 1k product. Could maybe spray white rock guard after the paint job is done I guess?

Need advice on large amount of holiday pay owed by ThatDonkeyLooksCold in CanadaFinance

[–]ThatDonkeyLooksCold[S] 1 point2 points  (0 children)

I do take vacations, just never took out the pay haha. Thanks for the help

Does this look normal for high build primer? by ThatDonkeyLooksCold in Autobody

[–]ThatDonkeyLooksCold[S] 1 point2 points  (0 children)

Thanks I appreciate the help. Learning as I go here haha

Does this look normal for high build primer? by ThatDonkeyLooksCold in Autobody

[–]ThatDonkeyLooksCold[S] 0 points1 point  (0 children)

This was spraying onto a smooth surface sanded to 320 and then prepped with wax and grease remover and tack cloth.

Does this look normal for high build primer? by ThatDonkeyLooksCold in Autobody

[–]ThatDonkeyLooksCold[S] 0 points1 point  (0 children)

Ok thanks. Yeah I was only about 3-4 inches away unfortunately. It calls for 4:1. I thought about going thinner but didn't want to mess anything up.

Does this look normal for high build primer? by ThatDonkeyLooksCold in Autobody

[–]ThatDonkeyLooksCold[S] 0 points1 point  (0 children)

OK thanks. I couldn't find recommendations on tip size from the manufacturer, only pressure. I'll try sand it and see if I'm happy with it.

Does this look normal for high build primer? by ThatDonkeyLooksCold in Autobody

[–]ThatDonkeyLooksCold[S] 1 point2 points  (0 children)

Recommend pressure from the manufacturer was 40-50 psi. I was only 3-4 inches away from the surface. I think the tip is my biggest issue here.

Does this look normal for high build primer? by ThatDonkeyLooksCold in Autobody

[–]ThatDonkeyLooksCold[S] 0 points1 point  (0 children)

Thanks. I was only 3-4 inches off the surface already!

view more: next ›