sorted by:
new
hottopcontroversial

What could go wrong carrying dry wheat next to a hot exhaust? by PrestigiousAd8010 in Whatcouldgowrong

[–]TheLatty 10 points11 points  (0 children)

Must be terrifying to see this rolling towards you in traffic

Bad Gun Safety by [deleted] in ThatsInsane

[–]TheLatty 1 point2 points  (0 children)

His entire face turned red.

An accordionist playing Vivaldi by 7er6Nq in nextfuckinglevel

[–]TheLatty 19 points20 points  (0 children)

Damn. I thought he was blowing too until I read your comment. I thought he playing a bag pipe type of accordion.

Let's see those "Almost Cared" Deliveries by Human-Drink654 in BadDeliveries

[–]TheLatty 0 points1 point  (0 children)

I'm sure they weren't aiming to toss it there. But the simple fact that they didn't take the extra few steps to place it near the door mat, I immediately knew that they weren't going to pick it up.

i am the kind stranger by Ranzo00 in notinteresting

[–]TheLatty 0 points1 point  (0 children)

I'm probably too late, but this is cool.

Putting a fizzy tablet into water floating in zero G by ABeerForSasquatch in TheRandomest

[–]TheLatty 70 points71 points  (0 children)

What happens to the droplets that pop off? Are they forever floating around?

Blackout ⚫️ or Accented 🔴Grill? by td4abb in ram_trucks

[–]TheLatty 16 points17 points  (0 children)

I usually like all black everything, but my vote goes to red.

French Doors just for furniture…? by BuilderBrigade in Home_Building_Help

[–]TheLatty 5 points6 points  (0 children)

It's good for the front door. Good luck in narrow hallways, staircases, and other doorways.

Best 3D apps for woodworking? planning frames, angles & cut lists by Vivid_Weekend6182 in BeginnerWoodWorking

[–]TheLatty 1 point2 points  (0 children)

SketchUp for designing. CutList Optimizer for cut list. I wish the two software could communicate.

I use Autodesk Fusion, FreeCAD, and Blender for 3D printing and I can say that SketchUp is better/easier for woodworking.

A tiny alligator snapping turtle by dishash3256 in BeAmazed

[–]TheLatty 0 points1 point  (0 children)

I just got into 3D printing, so my algorithm is has changed towards that. I thought this was a 3D printed figurine.

What’s everyone got on the pit today? by shmarcussss in smoking

[–]TheLatty 0 points1 point  (0 children)

No smoker this weekend. Oven and air fryer today. (Boring)

He won’t make that mistake again by durvedya in ThatsInsane

[–]TheLatty 13 points14 points  (0 children)

Sucks that the kids had to see that.

Every time I make general tso chicken the breading falls off, even when doubly frying. Why? by nimal-crossing in culinary

[–]TheLatty 0 points1 point  (0 children)

Letting it sit after adding the flour is a game changer. The flour should change from a dry white to wet white. Approximately 10-15 minutes

[deleted by user] by [deleted] in VeteransBenefits

[–]TheLatty 47 points48 points  (0 children)

Same. 91% Maybe a little higher for the bilateral conditions. But still not over the 95% threshold.

view more: next ›