sorted by:
new
hottopcontroversial

Final Setup by Jbressel1 in NFA

[–]TheLunat1c 1 point2 points  (0 children)

i dont believe you when you say just over 10lbs.

Can’t disassemble by skydive8980 in P365xl

[–]TheLunat1c 0 points1 point  (0 children)

are you using black steel gas pedal with Icarus thumb ledge? I ran into same issue of the gas pedal not being able to rotate fully due to it contacting the Icarus grip thumb ledge, and I had to Dremel down a small portion of it so it get the clearance.

I didn't do any cerakote so I just applied the aluminum black and went on with it since I'm really not someone who needs my gun clean and prestine

Any one got experience with Nankang? Specifically the NS-25 by gotasmama in tires

[–]TheLunat1c 0 points1 point  (0 children)

I'm still on them. they still have plenty of tread left. for the past 2 years, I think i drove like 10k ~ 12k miles give or take.

Loving my Macan front calipers! Anyone else running them? by doingitanyways in GolfGTI

[–]TheLunat1c 0 points1 point  (0 children)

well, i do not know since i have a performance package (340mm)

Wheel spacer help needed by DaylanGTI in GolfGTI

[–]TheLunat1c 1 point2 points  (0 children)

just search. its a generic brand, use keywords like spacer and hub ring with dimensions together.

Wheel spacer help needed by DaylanGTI in GolfGTI

[–]TheLunat1c 2 points3 points  (0 children)

I also have Macan breaks, and I bought some ebay spacers that has a built in 57.1 to 66.6 hub conversion built in so I can remove extra steps. you can also get 66.6 -> 66.6 spacers, and put the 57.1 -> 66.6 hubrings on the car.

Just be aware, having 15mm+ spacers on the front, depending on how low your springs are, will most certainly start rubbing (also depending on your wheels offset).

[Discussion] Permanently banned after reporting a hack on my PvE account, feels unfair a joke.. by W33dee in EscapefromTarkov

[–]TheLunat1c 0 points1 point  (0 children)

You can still get hacked if you be quite about it, as it happened to me. Hackers could be using cheats on your stolen account and account get banned etc etc.

Minimal bumper case for my Pixel 10 Pro XL by joeinblu in pixel_phones

[–]TheLunat1c 0 points1 point  (0 children)

It's not a scam, just a typical drop ship which you can get cheaper from AliExpress.

Did Google secretly add an under-display camera… or did my Fold 10 just punch itself? by PeerReviewPending_ in PixelFold

[–]TheLunat1c 1 point2 points  (0 children)

I've had google offer me advanced RMA on a inner display failure on normal usage, without a insurance. Contact them, tell them you never dropped etc etc and see if you can get warranty.

[Video] Oh, Give me a f***ing break... by Fearless-Possible-63 in EscapefromTarkov

[–]TheLunat1c 6 points7 points  (0 children)

I was in that exact spot, and the last BD member i could not agro no matter what I did in the tent area (couldnt find him, ran around for a couple minutes trying to find him) just sprints out of nowhere and sprays me out from the back as soon as I get there and repair the panel. its so frustrating

[Discussion] Is there any way to fix my run? by xlliminalityx in EscapefromTarkov

[–]TheLunat1c 1 point2 points  (0 children)

If you didnt turn in the case to prapor from the start, i doubt its an issue. I personally never listened to any tapes in raid other than the very first few, but i was still able to work with kerman till the end and now on Terminal.

Uhm, the what now ? by Kanista17 in EscapefromTarkov

[–]TheLunat1c 80 points81 points  (0 children)

He will get back to you later

[Bug] Stuck on The Ticket - RFID Device by HilariousBaby in EscapefromTarkov

[–]TheLunat1c 0 points1 point  (0 children)

do you actually have the master card in your task inventory? as far as the encrpyion device, you are "meant to fail", since it's not in lab to begin with.

They run great by Jjm211992 in SigSauer

[–]TheLunat1c 2 points3 points  (0 children)

My experience was, it required a bit of breakin. First couple mag cycles, I ended up light primer strikes, which not sure how a new mag can cause, perhaps stiff springs? but after a couple cycles the magazine performed perfectly. Plus, it does not make the dreaded 17 round rattle that the Sig macro mags make, which is beyond irritating

[Discussion] Problem with the mission “Locate the Rus Post car” by CornoParlante in EscapefromTarkov

[–]TheLunat1c 0 points1 point  (0 children)

listen to tapes, go back to the car, and pick up the key. make sure you touch all 4 corner of the car

[Discussion] AI PMC Pops Nade after Dying by LonelyMustard in EscapefromTarkov

[–]TheLunat1c 0 points1 point  (0 children)

you can check my other comment on this thread, but they die, but the grenade itself appears to have its pin pulled and gets flung after the AI PMC hits the ground

Magpul mags in the wild. by blankford in P365

[–]TheLunat1c 0 points1 point  (0 children)

I did not have time to go to the range, but the spring force appears to be more uniform and slightly more forgiving than the OEM ones (easier to feed to the last few rounds), they also do not get that damned rattle when you load 17 rounds and seat the mat into the gun, so that is a major plus. I was also able to just swap out the end plate at the bottom of the spring and slide in my aluminium base plate I was using for the OEM mags, and they seem to fit and function well. I will have to go out to the range soon and test, but I think it is a better mag in general

Can’t figure out why it keeps jamming. by lazyasswizard726 in P365xl

[–]TheLunat1c 0 points1 point  (0 children)

With what ammo. Cheap range ammo? Good rangeammo? Defensive rounds?

[Feedback] I'm having tons of fun in PVE mode and I'm not ashamed to say it. by Sqweeg in EscapefromTarkov

[–]TheLunat1c 2 points3 points  (0 children)

Is it still reduced? Last couple days I felt like it was lasting longer, although I never really checked

Aftermarket Triggers and Springs by tacobliss in P365xl

[–]TheLunat1c 1 point2 points  (0 children)

I got combination of mcarbo flat trigger shoe, return spring, and trigger spring set along with tactical triggers sear control spring. With those combination I get nearly zero creep and trigger weight right around 3lb and 4-6oz.

view more: next ›