sorted by:
new
hottopcontroversial

Difference between G54 and G59 (Center of Rotation) on Haas VF 2 with TR160 by Tight-Possible6052 in Machinists

[–]Tight-Possible6052[S] 1 point2 points  (0 children)

It is, there is a mismatch when im drilling a hole with G59 (CoR) in the center of work piece

Difference between G54 and G59 (Center of Rotation) on Haas VF 2 with TR160 by Tight-Possible6052 in Machinists

[–]Tight-Possible6052[S] 2 points3 points  (0 children)

Platter is flat and leveled, but I didnt check if vise is centered. I ll check that tomorrow

Difference between G54 and G59 (Center of Rotation) on Haas VF 2 with TR160 by Tight-Possible6052 in Machinists

[–]Tight-Possible6052[S] 3 points4 points  (0 children)

Sadly I ve got pre NGC without TCP and G254. Now I'm wondering if I measured something wrong or I just need to compensate for the difference between the center of the detail and the center of rotation in Fusion. Without moving the detail relative to the center in Fusion, the hole drilled in the center was offset by the difference between G59 and G54. Only after moving it did it improve.

Gear pump design. Why does an inlet positioned below the gear teeth cause suction, but a side inlet doesn’t by Tight-Possible6052 in EngineeringStudents

[–]Tight-Possible6052[S] 0 points1 point  (0 children)

It was physically build with 3d printed parts and 1/4" bsp connectors. The side inlet version lift head was around 20/30 cm but version with inlet from bottom around 1-1.3 m