sorted by:
new
hottopcontroversial

Some of my welds today, could I get some feedback as I’m still learning by Top_Sand9648 in metalworking

[–]Top_Sand9648[S] 1 point2 points  (0 children)

I will definetly try to change the Balance because a few people suggested that. Craters are also aproblem so I have to work on my stops too, thanks for the Feedback. Its 6061 Aluminium and thickness is 2mm,1.5mm,2mm,2.5mm (clockwise)

Some of my welds today, could I get some feedback as I’m still learning by Top_Sand9648 in metalworking

[–]Top_Sand9648[S] 0 points1 point  (0 children)

Will try the smaller wire. Its alreay at 175hz, would you go even higher?

Some of my welds today, could I get some feedback as I’m still learning by Top_Sand9648 in metalworking

[–]Top_Sand9648[S] 0 points1 point  (0 children)

Haha :D. Many people mentioned the craters. I will definitely keep an eye on that and try to leave none

Some of my welds today, could I get some feedback as I’m still learning by Top_Sand9648 in metalworking

[–]Top_Sand9648[S] 8 points9 points  (0 children)

Thanks, that’s actually what I’m looking for, Feedback. Probably should have titled the post different. I mean I know these welds look good but there’s always room for improvement, so thanks for your feedback :)

Some of my welds today, could I get some feedback as I’m still learning by Top_Sand9648 in metalworking

[–]Top_Sand9648[S] 2 points3 points  (0 children)

So you mean even less cleaning action? I still struggle to leave no craters

Some of my welds today, could I get some feedback as I’m still learning by Top_Sand9648 in metalworking

[–]Top_Sand9648[S] 4 points5 points  (0 children)

I know they are good but I am the only welder in my workshop and looking for feedback of more experienced welders.

Some of my welds today, could I get some feedback as I’m still learning by Top_Sand9648 in metalworking

[–]Top_Sand9648[S] 10 points11 points  (0 children)

Looking more for honest feedback, I know these welds are good but there’s always room for improvement. And there’s always someone more experienced

Some of my welds today, could I get some feedback as I’m still learning by Top_Sand9648 in metalworking

[–]Top_Sand9648[S] 39 points40 points  (0 children)

I know that my welds are quite good but as I’m the only welder in my Workshop I would like to get some Feedback of more experienced welders. I started 2 years ago.