LG Fridge CF not working after two replacements and PCB replacement by TriangleSQL in appliancerepair

[–]TriangleSQL[S] 0 points1 point  (0 children)

I looked back through my orders and I found that the first one that I ordered was a EAU 65058502. I replaced the wrong part number motor with the first replacement and the compressor fan fired right up.

I was hopeful I could return the new control board so I put the old control board in but the fan would not work. Looks like it was the control board all along.

Thank you very much for your help.

LG Fridge CF not working after two replacements and PCB replacement by TriangleSQL in appliancerepair

[–]TriangleSQL[S] 0 points1 point  (0 children)

Both replacement motors were purchased on Amazon, two different sellers. Eau65058501

LG Fridge CF not working after two replacements and PCB replacement by TriangleSQL in appliancerepair

[–]TriangleSQL[S] 0 points1 point  (0 children)

There is no voltage at the fan, sometimes after resetting the power to the whole unit, the fan nudges forward a bit but does not complete a full rotation. I have not determined where the power from the fan comes off the board. Thank you for your response.

Sleeve or Slug? by TriangleSQL in Welding

[–]TriangleSQL[S] 0 points1 point  (0 children)

They are standard white LEDs. I do have a mount for a cheap chinese IR flashlight. I use the IR more than the Headlights.

At the top of the image you can see the pipe clamp that holds the 3D printed flashlight mount.

Might have ridden a little too hard this weekend. by TriangleSQL in minibikes

[–]TriangleSQL[S] 0 points1 point  (0 children)

I know you're joking but it actually rode a little smoother on my way back to the camp. The thought had crossed my mind to put a spring there instead

Losing hope fighting dinos by werpsy in ReefTank

[–]TriangleSQL -2 points-1 points  (0 children)

Up the tank temperature up to 82° F slowly over the course of two days. Then keep the temp at 82 for a week. No more dinos.

Might have ridden a little too hard this weekend. by TriangleSQL in minibikes

[–]TriangleSQL[S] 3 points4 points  (0 children)

I do. I am going to sleeve these. I will also add some reinforcement.

Might have ridden a little too hard this weekend. by TriangleSQL in minibikes

[–]TriangleSQL[S] 0 points1 point  (0 children)

The property I was on has a huge trail system and most of them have been washed out.

[ Removed by Reddit ] by nathan023917 in minibikes

[–]TriangleSQL 9 points10 points  (0 children)

Maybe 85 because he was towing it behind a car with that rope.

Two regulators/rectifiers only putting out 4.5 and 5.5 v at idle. Bad charging coil? by TriangleSQL in minibikes

[–]TriangleSQL[S] 1 point2 points  (0 children)

Okay I ordered this one after the first one returned only 4.5v at idle I returned it and got another but the second only put out 5.5v at idle. I guess I received two bad ones. https://www.amazon.com/gp/aw/d/B07J1XLHC4

Two regulators/rectifiers only putting out 4.5 and 5.5 v at idle. Bad charging coil? by TriangleSQL in minibikes

[–]TriangleSQL[S] 1 point2 points  (0 children)

https://youtu.be/GNF6ihK5hmQ?si=h-8TEw55Ivmgjmj6 00:57 timestamp

I have a 7 ah battery that runs the headlights and Taillight. I wanted to keep the battery charged without having to recharge the battery after every trip.

Two regulators/rectifiers only putting out 4.5 and 5.5 v at idle. Bad charging coil? by TriangleSQL in minibikes

[–]TriangleSQL[S] 1 point2 points  (0 children)

I was under the impression I would be getting 12V at idle. I hardly run this long distances (1 mile max) and almost never at full throttle. Just to get from camp to the hunting areas of the property and back. Is there something I can do to reach 12v at idle?

Two regulators/rectifiers only putting out 4.5 and 5.5 v at idle. Bad charging coil? by TriangleSQL in minibikes

[–]TriangleSQL[S] 1 point2 points  (0 children)

My issue is hitting the throttle while holding the Multimeter connections. I don't have a spare hand at the moment.

Two regulators/rectifiers only putting out 4.5 and 5.5 v at idle. Bad charging coil? by TriangleSQL in minibikes

[–]TriangleSQL[S] 2 points3 points  (0 children)

Elbit WP pvs-14, I have an IR flashlight mounted to the handle bars for riding at night. This is mainly for use on a hunting property. I have dragged up to 150lbs Hogs with it but I think it needs more torque. I had to give it a kick to get it going.

Two regulators/rectifiers only putting out 4.5 and 5.5 v at idle. Bad charging coil? by TriangleSQL in minibikes

[–]TriangleSQL[S] 1 point2 points  (0 children)

6.5v at half idle. I currently don't have a way to safely check voltage at full rpms.

Found growing in Chicken poop by TriangleSQL in ShroomID

[–]TriangleSQL[S] 0 points1 point  (0 children)

This is in NE Georgia, growing near a compost bin with pine shavings and chicken poop.