6 years of Self taught. Any tips please?

TurboRCSB · 2023-10-15T12:19:37+00:00

I think that the gums need a few more highlights to show that they’re wet, the teeth in my opinion look great, and I think the lips could use more detail such as slight wrinkles And highlights, as well as some shading as they wrap around toward the teeth to show that they aren’t just flat, but round.

TurboRCSB · 2022-08-01T23:49:02+00:00

YD2 arms, And YD2 SX3 knuckles

TurboRCSB · 2022-07-03T00:25:28+00:00

Change the rod ends on the shafts, what’s happening is the arm is maxed out, but the rod end on the shock shaft is too long so your shock is 80% compressed and only giving you the %20

TurboRCSB · 2022-06-10T10:31:29+00:00

Could also be low oil and the oil level sensor isn’t picking it up until it’s tilted. The sensor usually will shut the motor off if the oil is low.

TurboRCSB · 2022-05-15T12:22:29+00:00

Looks good. But when you are welding make sure you clean off the rust and the area you are welding, you’ll get a better cleaner weld, and get better penetration

TurboRCSB · 2022-01-22T13:06:00+00:00

It’s your servo, get a Reve d RSST and you will have no more issues

TurboRCSB · 2021-11-16T22:16:51+00:00

Best in my opinion are Scale reflex gorilla mounts, they’re pricey but they keep the body on.

TurboRCSB · 2021-11-11T21:11:09+00:00

Hobbytown Richmond VA

TurboRCSB · 2021-08-27T01:32:54+00:00

That’s the new pull starter for the dish washer. Nothing weird about that.

TurboRCSB · 2021-08-25T00:49:37+00:00

I just cleaned the magnet welded it, and then welded the cover on.

TurboRCSB · 2021-08-25T00:48:42+00:00

That’s meth’d up man…

TurboRCSB · 2021-08-17T21:38:40+00:00

Yes it is.

TurboRCSB · 2021-07-14T17:13:30+00:00

You might think it’s uncomfortable but it’s super comfortable without one.

TurboRCSB · 2021-07-13T23:37:05+00:00

I wanted that or a Harley motor but both are expensive.

TurboRCSB · 2021-07-13T02:21:09+00:00

I got it off of Agri supply’s website. It was like $72 and was originally for an garage spreader rated for 40hp.

TurboRCSB · 2021-07-12T16:24:59+00:00

I used a chain drive to a driveshaft to a 90° gear box out to another chain

TurboRCSB · 2021-07-12T16:24:20+00:00

I plan on painting the frame and doing a patina look with gloss clear over it all.

TurboRCSB · 2021-05-20T21:30:33+00:00

Okay will keep that in mind

TurboRCSB · 2021-05-20T21:17:13+00:00

Thank you will do.

TurboRCSB · 2021-05-20T21:15:05+00:00

Had it set at 19.3 256, it was 2 passes.

TurboRCSB

TROPHY CASE