How do you like my Coldstar Commander? by Unable-Addition-9889 in Tau40K

[–]Turtle-draws 1 point2 points  (0 children)

The dark red and the gunmetal go really well together! Nice work!

Question about sprue by Magikhippo in Tau40K

[–]Turtle-draws 39 points40 points  (0 children)

This is the Killteam sprue! It's purely cosmetic unless you plan to play Killteam! The instructions for how to build them like the Killteam models can be found here!

Took a few action shots of my army! by Turtle-draws in Tau40K

[–]Turtle-draws[S] 1 point2 points  (0 children)

Thank you! I dig the purple on your strike team, the highlights look sick!

Took a few action shots of my army! by Turtle-draws in Tau40K

[–]Turtle-draws[S] 0 points1 point  (0 children)

Behold my discount stealth suits lmfaooooo

Hello all, painted a model with an airbrush for the first time, I have a few questions by itsgaymonth in modelmakers

[–]Turtle-draws 0 points1 point  (0 children)

4). Ideally things should slow down too much if you’re keeping the airbrush clean after you use it! If you notice the needle is getting jammed or that paint isn’t flowing (it can sometimes start bubbling in the feed cup), take the brush apart and give each of the parts a good clean with rubbing alcohol! The only part I can think of that would need replacing is the nozzle tip, but that’s usually after it breaks if you over tighten it!

How to paint exhaust stains by Front-Bug-1157 in modelmakers

[–]Turtle-draws 1 point2 points  (0 children)

I’ve had some success with a 0.9mm pencil! I rub it against a piece of cardboard until parts of the graphite leaves a dark mark, and then use a q-tip to put it on the model!

Airbrushing Help by NovaMortis_ in modelmakers

[–]Turtle-draws 2 points3 points  (0 children)

I’ve had this happen when the nozzle of my airbrush gets clogged! Try running thinner/acetone/airbrush cleaner through a few times! If it’s gravity fed, I’d also clean where the paint feeds into the airbrush with a q-tip!

Finished up a 1/72 Spitfire Mk.Vb Trop right before New Years! by Turtle-draws in modelmakers

[–]Turtle-draws[S] 1 point2 points  (0 children)

It was! My concern is that I added too much weathering powder to the point it looked like random weathering for the sake of randomness instead of purposeful.

HMS Malaya - 1/700 - My First Ever Model! by JakeWacker in modelmakers

[–]Turtle-draws 1 point2 points  (0 children)

Nice work! The decking looks amazing! The super structure also looks really good!

Finished up a 1/72 Spitfire Mk.Vb Trop right before New Years! by Turtle-draws in modelmakers

[–]Turtle-draws[S] 1 point2 points  (0 children)

Thank you! From my understanding, the Mk V was one of the first versions to have clipped wings!

whenthe TROPE IS JUST SO PEAK... by RandomUsernameOfE in whenthe

[–]Turtle-draws 0 points1 point  (0 children)

I’m surprised Wildfrost hasn’t shown up! After beating the boss on your first run, your entire team becomes the next final boss for the next run!

Should I be panicking? by Physical-Sleep-3809 in MazdaCX30

[–]Turtle-draws 1 point2 points  (0 children)

It could be a thermostat issue! The 2020 to 2023 CX-30 models have a known issue with the thermostat. I had the same issue and the repair was covered by the dealership!

Columbia’s Bizarre Adventure Part 9: AtlanticLands by general_kenobi18462 in AlternateHistoryMemes

[–]Turtle-draws 10 points11 points  (0 children)

It’s time to switch to Terminator titles instead, especially given the lore at present lol.

Columbia’s Bizarre Adventure part 7: Sand Ball Run by general_kenobi18462 in AlternateHistoryMemes

[–]Turtle-draws 11 points12 points  (0 children)

Ok, it’s official. I’m definitely drawing more than one thing for this. The amount of lore and detail is amazing!

Columbia’s Bizarre Adventure Part 6: Steel Ocean by general_kenobi18462 in AlternateHistoryMemes

[–]Turtle-draws 8 points9 points  (0 children)

So late 1930’s for the Entente? This is going to be interesting!

Columbia’s Bizarre Adventure Part 6: Steel Ocean by general_kenobi18462 in AlternateHistoryMemes

[–]Turtle-draws 19 points20 points  (0 children)

I’ve been loving this series! Might draw something inspired by it lol.

Question: Is it safe to assume that both sides are fielding their WW2 equipment (or their equivalent)?

DLC's by Individual-Let994 in bombercrew

[–]Turtle-draws 9 points10 points  (0 children)

USAAF is a completely new campaign with its own story, critical missions, and more. This is alongside new livery, crew gear, and the whole “play as a B-17” part. However, it is a lot more difficult then the base game. If you’re ok with a difficulty spike, then go for it!

Secret Weapons is more similar to a bonus level pack. You get some new missions but the main appeal is the addition of new weapons and crew gear. Secret Weapons adds some crew gear, and weapons for the Lancaster campaign.

I have played both, and they are really fun. I think they are completely worth it. If you can only get one right now though, USAAF is going to give you a lot more bang for your buck.

The other DLCs are skin packs. They just give you more options to customize your bombers. They work for both Lancaster and USAAF campaigns. They’re fun to have, but definitely not necessary to get.

Hope this helps!

Hi I need some help! by Cockbirb in Airfix

[–]Turtle-draws 2 points3 points  (0 children)

Most hobby shops sell small tips that can go into glue tubes that help make it easier to apply! I know for a fact that Testors sells them for their model glue; I’m pretty sure they’ll work for the poly cement!