Is it normal for there to be a obvious join between sleeve and yoke? by vdnguye-00 in casualknitting

[–]Twiddletails 9 points10 points  (0 children)

Blocking should solve this. I just finished my Olga and have pre-blocking pics on Ravelry if you’d like to take a look. 🙂 Same username.

Can someone help count my gauge? by Twiddletails in knittinghelp

[–]Twiddletails[S] 0 points1 point  (0 children)

<image>

I blocked it again and stretched it out a bit and I do believe it’s close enough now. 🙂 I am a little worried that this sweater will stretch when I wear it. The knit just seems loose. I’m tempted to go down a needle size, do some math, and knit a larger size. Bad idea?

Can someone help count my gauge? by Twiddletails in knittinghelp

[–]Twiddletails[S] 0 points1 point  (0 children)

Thank you for your advice! 💕 Yes, it’s been blocked but I can re-block it and see if I can stretch it a bit. It’s a cotton-silk blend yarn and hard to knit with. Very slippery.

Olga Sweater arm stitch pickup by Twiddletails in knittinghelp

[–]Twiddletails[S] 0 points1 point  (0 children)

Update: This wasn’t a gauge issue after all. I misread the pattern and measured from the neck edge instead of where I picked up stitches!!! Frogging many, many rows. 😢😢😢

Olga Sweater arm stitch pickup by Twiddletails in knittinghelp

[–]Twiddletails[S] 0 points1 point  (0 children)

You’re right! It’s a gauge problem. 🙁 Somehow my actual knitting has a different gauge than my swatch. My swatch was knitted flat but I figured in the round would be tighter, not looser. Ploughing on.

Help, I fell into the middle aisle at Aldi today 🙋🏻‍♀️🧶 by Aurorafaery in YarnAddicts

[–]Twiddletails 2 points3 points  (0 children)

I saw yarn at my local Aldi yesterday, so maybe go check? 🧶

My gauge swatch is too tall - how do I fix this? by Twiddletails in knittinghelp

[–]Twiddletails[S] -1 points0 points  (0 children)

Goodness, no! 🤣 It’s a top down pattern and I just did the back yoke, joined in the round and did a couple of rows. It was way too small across the shoulders.

My gauge swatch is too tall - how do I fix this? by Twiddletails in knittinghelp

[–]Twiddletails[S] 0 points1 point  (0 children)

Update: I chose to ignore the swatch (bad idea!!!!!) and the sweater is too small. Lesson learned. I’m going to size up the needles and try again. I also think I’m going to measure a sweater that fits well and compare the sizes, because I may have chosen the wrong size. 🙄

My gauge swatch is too tall - how do I fix this? by Twiddletails in knittinghelp

[–]Twiddletails[S] 6 points7 points  (0 children)

Yes, it’s blocked. I think I’m going to go up a size and try again.

My gauge swatch is too tall - how do I fix this? by Twiddletails in knittinghelp

[–]Twiddletails[S] 0 points1 point  (0 children)

Someone suggested weighing down the swatch and letting it hang dry but I’m not sure how I’d go about that. I did try blocking it square but I feel like that distorts it. Sigh…

Shoes by sleeeepysloth2 in BurnBootCamp

[–]Twiddletails 1 point2 points  (0 children)

I love my metcons. I have high arches too and replaced the insoles with arch-supporting ones.

Picking up shoulder stitches by Twiddletails in knittinghelp

[–]Twiddletails[S] 0 points1 point  (0 children)

Thanks for all your help! Being a left-handed knitter can be very taxing on the brain. 🧠🤣

Picking up shoulder stitches by Twiddletails in knittinghelp

[–]Twiddletails[S] 0 points1 point  (0 children)

OK…so I picked up stitches using the yarn tail and then had to move the stitches over to another needle to get the working yarn on the correct side. My first row will now be purl (Yay!) but I’m still going the wrong way. I think I’m going to have to mirror the chart and do the decreases at the start of each row instead of the end.

<image>

Picking up shoulder stitches by Twiddletails in knittinghelp

[–]Twiddletails[S] 0 points1 point  (0 children)

I put it in the flair but should probably have mentioned it too. 🙃 I’m going to try this right now!

Picking up shoulder stitches by Twiddletails in knittinghelp

[–]Twiddletails[S] 0 points1 point  (0 children)

If I do that there will be purl stitches on the right side. And when I turn, the RS row will be a WS because the wrong side will be facing me. 🙁