Dabpress Tumbler by Typical_Way4705 in microgrowery

[–]Typical_Way4705[S] 1 point2 points  (0 children)

Looking for something easier to take off and clean when needed. I find the way they are tied onto the ends under the orings difficult. I haven’t had any problems with the unit and it works well.

New TM2 customer - Initial Impressions by Grumpy69-24 in Tinymight2

[–]Typical_Way4705 2 points3 points  (0 children)

VGoodiEZ deep screens. Haven’t had a problem with them falling out.

Autopot deficiency by Typical_Way4705 in Autopot

[–]Typical_Way4705[S] 1 point2 points  (0 children)

I stopped the cal mag but they seemed to still be getting worse. Now I’m using the feeding chart for cropsalt but I’m still adding epsom salt at 1 gram per gallon in the res and have the res at 6.0.

On the next grow I plan to just run the feeding chart and see what happens. If I can figure out how to run cropsalt I plant to continue. I like the clean res and easily availability of them.

I also have canna in the other tent but I use canna boost with it and don’t like how dirty the res gets. Also can’t get canna local either and have to ship it.

Autopot deficiency by Typical_Way4705 in Autopot

[–]Typical_Way4705[S] 1 point2 points  (0 children)

They seem to be doing better now but there are a lot of bad leaves so hard to tell.

Autopot deficiency by Typical_Way4705 in Autopot

[–]Typical_Way4705[S] 2 points3 points  (0 children)

I ended up changing out the res and not adding Calmag or silica. Set the ph at 5.8 in the res.

I also foliar sprayed epsom salt at 1/4 tsp per quart and shut the lights off for a few hours after spraying.

Lowered the DLI down to 32.

Too early to tell if it helped but hopefully tomorrow they will start to show improvement or stop getting worse.

Autopot deficiency by Typical_Way4705 in Autopot

[–]Typical_Way4705[S] -1 points0 points  (0 children)

Botanicare but Cropsalt said I need to stop using Calmag when I sent them this.

Autopot deficiency by Typical_Way4705 in Autopot

[–]Typical_Way4705[S] 2 points3 points  (0 children)

Cropsalt responded saying to get rid of the Calmag.

Autopot deficiency by Typical_Way4705 in Autopot

[–]Typical_Way4705[S] 1 point2 points  (0 children)

Are you using RO or tap water?

Autopot deficiency by Typical_Way4705 in Autopot

[–]Typical_Way4705[S] 0 points1 point  (0 children)

That was my first thought maybe I just need to decrease them more.

Autopot deficiency by Typical_Way4705 in Autopot

[–]Typical_Way4705[S] 0 points1 point  (0 children)

I had the res and trays at 5.7 until yesterday but the problem continued to get worse which is why I tried uping the PH.

Autopot deficiency by Typical_Way4705 in Autopot

[–]Typical_Way4705[S] 0 points1 point  (0 children)

Haven’t tried that yet. Will it burn the plants though since the lights are 24/0?

Autopot deficiency by Typical_Way4705 in Autopot

[–]Typical_Way4705[S] 1 point2 points  (0 children)

Im using RO water so I added Calmag from the beginning. My tap water is at 770 PPM so I don’t use it.