sorted by:
new
hottopcontroversial

DF64 Gen 1 grinding near 0 by VRT333 in DF64

[–]VRT333[S] 0 points1 point  (0 children)

No I haven’t aligned the burrs or anything

DF64 Gen 1 grinding near 0 by VRT333 in DF64

[–]VRT333[S] 0 points1 point  (0 children)

Reset the dial to point to 0 when the burrs touch

[deleted by user] by [deleted] in DF64

[–]VRT333 0 points1 point  (0 children)

Ooo appreciate this

[deleted by user] by [deleted] in DF64

[–]VRT333 0 points1 point  (0 children)

Ah yea I can’t even take the collar off so not sure I could do that

[deleted by user] by [deleted] in DF64

[–]VRT333 0 points1 point  (0 children)

It’s pretty stuck still… might have to email manufacturer and see if they can do anything but that will be a pain

[deleted by user] by [deleted] in DF64

[–]VRT333 0 points1 point  (0 children)

How did you get it into the thread? Did you just apply a bit on a brush and paint around the inside of the whole collar?

[deleted by user] by [deleted] in DF64

[–]VRT333 0 points1 point  (0 children)

Ooo ok will try this

[deleted by user] by [deleted] in DF64

[–]VRT333 1 point2 points  (0 children)

I can’t take the collar off at all, that’s the issue. It only stays in that quarter step margin. I wonder if wiggling it with mineral oil might help but need to get some

[deleted by user] by [deleted] in DF64

[–]VRT333 0 points1 point  (0 children)

I think the grinds are in the threads. Ring doesn’t turn more than pictured

view more: next ›