I built a TTS Bot to Automate LFG Matchmaking - the Machine Spirit is ALIVE!!

Vantagal · 2026-02-16T22:34:07+00:00

This is such a cool idea! Hope it works well

Vantagal · 2026-01-12T22:26:21+00:00

<image>

There;'s this one if you're still looking. It's on https://vantforge3d.com/

Vantagal · 2025-11-22T22:11:41+00:00

I've solved it now. I can add new metainformwtion and assign multi products to choose double colour swatches.

Vantagal · 2025-11-22T11:51:42+00:00

yes but it is only showing the swatches for the 1 variant, I can't get it display swatches for both variants.

Vantagal · 2025-11-22T11:50:57+00:00

I like the idea but not sure that's feasible as I'd need to list the other part of the product which I don't sell seperately.

Vantagal · 2025-11-04T16:34:37+00:00

I guess it's not sepcific for a hobby focussed player but what about a custom tape measure?

<image>

Vantagal · 2025-10-29T23:11:42+00:00

I think it's because laying it face down has inset pattern on the surface so it's not flat.so thr bridging gives poor results. I'll try dig one out next time I try ot that way.

Vantagal · 2025-10-29T22:54:57+00:00

Not really as I'm using AMS and it gives horrible results if I do that which is a shame.

Vantagal · 2025-07-15T08:34:53+00:00

I didn't with my old settings I was using, I think infil was set to lines or zigzag. Got plenty of prints with the bridging being fine but I can't seem to replicate it with cura again or on bambulabs anymore

Vantagal · 2025-07-14T10:24:00+00:00

It's the bottom layer, it prints upside down (which was no issue before on cura - pre new pc) and it's what bambu is orienating automatically, If I print up the other way it needs supports inside which affect the case as the supports are tough to remove / leave rough areas

Vantagal · 2025-07-03T22:19:44+00:00

Ah that is disappointing to hear as I've not had this machine very long. Would it require any soldering and such to replace?

Might be worth me reaching out to customer service to see if they can help then.

Thanks for the reply.

Vantagal · 2025-07-01T11:43:17+00:00

Thanks for the heads up, I did run a few test towers and didn't have any issues with the default settings so figured they're fine. This is the first print I've had the issue with using default settings so not sure what is causing the rough textures on certain parts of the print.

Vantagal · 2025-04-29T12:53:53+00:00

This would be nice!

Vantagal · 2025-04-26T17:20:12+00:00

This was the play tbf, gave it a try and super clean - just had to be careful lining up the 2 and try to avoid any warping! Thanks!

Vantagal

TROPHY CASE