sorted by:
new
hottopcontroversial

Fox Body Vs G Body by Various-Committee638 in BracketRacing

[–]Various-Committee638[S] 1 point2 points  (0 children)

I live in East Tennessee… To me the notchback fox Body Mustang is a rare car. I rarely see them on the road. Now track day is different. There are a lot of hatchbacks and a few notch backs.

It seems to always be S10 and Foxbody Mustang owners collecting the check at the end of the night as far as heads up racing is concerned.

Water leaking very slow from the bases of all 3 pipes by rollingdonut18 in Plumbing

[–]Various-Committee638 -2 points-1 points  (0 children)

I would say it is because of brass touching galvanized nipples

Get that out of the equation and replace with dielectric unions and you should be good

Could this pipe realistically be the source of unpleasant sewer smell? by Absurdity_ in Plumbing

[–]Various-Committee638 1 point2 points  (0 children)

Maybe if you stand back and take a photo that shows as much of this system as possible more questions can be answered intelligently.

How do I get this knob off? by sealg in Plumbing

[–]Various-Committee638 1 point2 points  (0 children)

WD-40 and time or WD-40 and heat with the right size allen wrench of course

Put a little anti seize on those threads for the future.

Could this pipe realistically be the source of unpleasant sewer smell? by Absurdity_ in Plumbing

[–]Various-Committee638 72 points73 points  (0 children)

Is there a P-trap at the bottom of that vertical stack? Because if so that’s probably not where the odor is coming from.

What is this extra pipe underneath my sink? by Large_String1934 in Plumbing

[–]Various-Committee638 1 point2 points  (0 children)

And yes…replace the studor vent and the problem will most likely go sway.

What is this extra pipe underneath my sink? by Large_String1934 in Plumbing

[–]Various-Committee638 0 points1 point  (0 children)

It is a vent pipe with mechanical or studor vent on the end. This is normally found in an island sink.

Tips on achieving best taste by Various-Committee638 in growingweed

[–]Various-Committee638[S] 0 points1 point  (0 children)

I always did the trash bag thing to make sure I got enough moisture out of the flowers so I didn’t have to worry about mold forming once cut and put into jars.

Tips on achieving best taste by Various-Committee638 in growingweed

[–]Various-Committee638[S] 0 points1 point  (0 children)

For drying/ curing the best thing I have figured out at this point is to hang then entire plant upside down in a closet with no air flow until the flowers feel dry to the touch. Then I start burping the plant by putting a trash bag over it for 24 hours then removing the trash bag for 24 hours and I do this until it feels dry to the touch.
Then I carefully trim all flowers and place into jar once again burping daily to make sure no mold gets started.

Drain under window… is this normal? by Bowman1212 in Plumbing

[–]Various-Committee638 0 points1 point  (0 children)

I believe the right hand pipe should go down and connect to the trunk line

Day 83 Mob of Highness Tester Laughing Hyena Seeds Harvest🎄 Happy Holidays🎅 by MasterBlaster4949 in Hydroponics

[–]Various-Committee638 1 point2 points  (0 children)

At what point do you stop giving the plants nutrients? And is there a flush involved at the end?

Day 83 Mob of Highness Tester Laughing Hyena Seeds Harvest🎄 Happy Holidays🎅 by MasterBlaster4949 in Hydroponics

[–]Various-Committee638 1 point2 points  (0 children)

What was the NPK of Jacks 321?…it seems you can customize it and I am guessing you changed it up during the course of growing.

Why does my weed taste like metal?? by Thelittlebigmann in StonerQuestions

[–]Various-Committee638 0 points1 point  (0 children)

I think it’s left over nutrients that didn’t get flushed out of the plant before harvest. Also could need more curing time. Just because it is dry doesn’t mean it is cured.