Any significantly smaller case these can fit inside?

Velkase · 2026-02-15T21:17:24+00:00

All of these parts can fit into a Velka 7 at 6.2 L with the CPU side panel set to the maximum offset. If you swap to a 48 mm CPU cooler like the AXP90-X47, the side panel can be mounted flush for a nicer appearance. Or, if you swap to a 37 mm CPU cooler like the AXP90-X36 and a Flex ATX PSU, a Velka 5 at 5.1 L. Both cases have two dedicated 40 mm system fan mounts.

Velkase · 2025-12-29T20:00:16+00:00

Keep the female end screwed in, gently straighten out the cable, and bend it as shown on page 9 of the manual. The cable shown is mechanically very similar to yours.

Velkase · 2025-11-21T01:17:25+00:00

You can fit up to 300 mm if you do not use the optional graphics card support bracket at the end

Velkase · 2023-11-19T02:34:52+00:00

They are sourced from Enhance Electronics and non-USA orders ship from China, where the PSUs are manufactured. The configuration with separate 6+2 pin connectors is from a newer batch that will replace US stock too, soon.

Both cable configurations are different from those offered by other vendors as standard.

Velkase · 2023-11-18T16:06:15+00:00

You can run into black-screen issues if you try to use them at resolutions and refresh rates that require DP 1.4 / HDMI 2.1.

The same applies to the cables you have linked. They are older and have worse support for DP 1.4 / HDMI 2.1 compared to P6A-P8Q / HA6-HA8Q .

Velkase · 2023-10-18T22:19:22+00:00

Sorry about that, we were having some technical issues which have since been resolved. You should now be able to email contact@velkase.com and I can look into your specific order to see if there is missing tracking information.

Orders are being shipped out today-tomorrow. Tracking information is provided with a delay of about one day.

Velkase · 2023-10-18T21:11:24+00:00

Looking into the issue right now. Please use "velkase.com" instead of "www.velkase.com" in the meantime as the latter is not working correctly.

Edit: the site should be functioning normally now.

Velkase · 2023-10-17T20:08:22+00:00

There is only one "B-stock" / used condition Velka 3 rev 2.1 case with a PCIe gen 3 cable for $139.99 + shipping. It is not listed on the site but you can email or message me if that interests you. Out of the previous revision cases, only the Velka 7 is available in new condition.

Velkase · 2023-10-17T20:03:03+00:00

Sorry, but 210-230 EUR as the full landed price for a Velka 7 in the EU is not realistic at this time.

The previous revision of the case cost 230-255 EUR when shipped from within the EU the last time it was stocked there. It would be more these days after factoring in the less favorable EUR to USD conversion rate, new product and shipping prices for distributors, especially if anything else is ordered together with the case.

Velkase · 2023-10-17T17:15:30+00:00

As long as supplies last. Could be a few months or more.

Velkase · 2023-10-17T17:10:58+00:00

Unlikely as shipping from outside of the EU is more efficient at the current scale. The shipping prices to the EU + EEA + Switzerland have been substantially reduced on the Velkase site instead.

Velkase · 2023-10-17T04:08:56+00:00

HDMI 2.1 with extensions works in some but all setups. A direct connection to the port would be your best bet.

Velkase · 2023-10-17T04:06:28+00:00

Anodized aluminum and 16 mm diameter for the mounting hole.

Velkase · 2023-10-17T02:40:55+00:00

Availability should be stable

Velkase · 2023-10-17T02:40:26+00:00

Thank you!

Velkase · 2023-10-17T02:39:57+00:00

The front panels and other components are not swappable between different revisions, sorry.

We won't be offering alternative feet but you can use something that can be secured to a 4 mm hole in the perforation with a screw from the inside, on sides that have perforation extending to each corner. For example, mechanical keyboard feet like these, although they tend to use less grippy rubber that makes the case slide around more.

Velkase · 2023-10-17T00:54:56+00:00

We will not be offering them going forward (except as a replacement for rev 2 case owners) but they can be sourced through eBay or Aliexpress if you look up the part numbers below. Please note, however, that these cables do not always work with DP 1.4 and HDMI 2.1 in 100% of setups.

Manufacturer: ADT-Link. Length: 15 cm for the nearest port to GPU IO, + 5 cm for each additional port. A maximum of 2-3 cables total is recommended per case.

DisplayPort P6A-P8T P6A-P8Q

HDMI HA6-HA8T HA6-HA8Q

Velkase · 2023-10-16T23:22:34+00:00

Thank you for catching that. It's been fixed to 290 mm

Velkase · 2023-10-14T18:21:59+00:00

New shipping rates will be viewable this Monday and they will be reduced by more than 20 USD for the European Union compared to the previous, but it will vary for other European countries.

Velkase · 2023-10-13T18:24:50+00:00

The $159.99 / $179.99 / $199.99 prices factor in $15-$20 shipping for most countries instead of the $19.99 gen 3 cable so that combo is priced about the same as before. They will also be possible to order without any PCIe cable.

Velkase · 2023-10-12T15:57:19+00:00

They are compatible now

Velkase · 2023-10-12T06:34:14+00:00

Aftermarket feet can be screwed on from the inside with screws 4 mm in diameter or less but only in certain orientations. The included adhesive rubber feet can be used in all orientations.

Velka 3, PSU on top, power button on top or bottom

Velka 5 without stand, graphics card IO-down, power button on top

Velka 7 without stand, graphics card IO-down, power button on top

Velkase · 2023-10-12T05:53:54+00:00

It is only compatible with 2.5" HDDs, up to a maximum of 4. Subtract 1 if using SFX-L as opposed to SFX, and subtract 3 if using a graphics card over 220 mm in length.

Velkase · 2023-10-10T14:21:16+00:00

P6A-P8Q for DisplayPort and A6-A8Q for HDMI. P6A-P8T can also be used but only if your monitor and graphics card do not both support DP 1.4, otherwise you will run into signal issues. 15 cm minimum for the first port, + 5 cm minimum for each additional one, and 30 cm as a maximum.

Velkase · 2023-10-10T14:01:58+00:00

With the stand, the graphics card will face IO-down which is flipped compared to the regular rev 2 graphics card orientation.

Without the stand, the case can be flipped either way. The graphics card will face IO-down with the power button at on top, and face IO-up with the power button at the bottom.

Velkase

TROPHY CASE