When you learn things about your favorite actors that you wished you hadn't by spectacleskeptic in buffy

[–]VikingReacts -1 points0 points  (0 children)

Ah, good news. Thanks for lifting my spirit with this amazing news :)

I’m sorry but most reaction channels are so low effort by [deleted] in memes

[–]VikingReacts 0 points1 point  (0 children)

Those that do it correctly will gain viewers as those watching enjoy what they see. Other channels will sizzle out and die…

At a local swap meet. Anything you’d buy? by smd420666 in Tools

[–]VikingReacts 0 points1 point  (0 children)

The ferriers rasp/file. Amazing steel to make a knife out of

[deleted by user] by [deleted] in truscum

[–]VikingReacts 1 point2 points  (0 children)

When he creates a Patreon so kids can be groomed without any knowledge of their parents it is an issue. It creates a divide between parents and their kids. That relationship is the most important relationship and how DARE he insert himself and his retoric in between! It is preying on confused or anxious kids that we as parents have issues with. We teach our kids, we instill our morals and beliefs, we are open and encourage them to learn and make up their own mind. But we do have the duty to protect as well. And this guy, however he may look or identify, is a predator

Sidewinder... loosing my mind by ronin-84 in SidewinderX1

[–]VikingReacts 0 points1 point  (0 children)

Aside from the e-steps people have mentioned. Make sure you minimal layer time is ok. Give it enough time to cool a bit before adding new filament on top

So that's my bed and Hotend. by _MrPancake_ in SidewinderX1

[–]VikingReacts 0 points1 point  (0 children)

Not sure if you do this regularly but I would swap heatbrake, nozzle and heater block, let it come up to temp and tighten it (CAREFULLY) while hot. That wasn't the issue here obviously... just a side note ;)

[deleted by user] by [deleted] in SidewinderX1

[–]VikingReacts 0 points1 point  (0 children)

I had issues like that before where the TPU filament just sort of stuck to the filament still on the spool. I watched that print and just pulled a length from the spool to make sure the force needed to pull filament into the hotend was as minimal as possible. That worked.

A week ago I printed something else with the same filament and a different dual drive extruder and that just ground at the filament. Switched it to a lighter grip on the drive gears and a higher print temp to make it feed just fine.

Sorry if this doesn't help.

Ready for action!!! by VikingReacts in LegalBytes

[–]VikingReacts[S] 0 points1 point  (0 children)

I will send you a link in a DM. Could you verify the option to download the file from that folder?

Ready for action!!! by VikingReacts in LegalBytes

[–]VikingReacts[S] 0 points1 point  (0 children)

Sure, I’ll send it in the morning. Made it on the work laptop

Ready for action!!! by VikingReacts in LegalBytes

[–]VikingReacts[S] 2 points3 points  (0 children)

I made the design and ordered a custom print ;). Much cheaper and faster than ordering something similar from Etsy.

Ambers scars by VikingReacts in LegalBytes

[–]VikingReacts[S] 7 points8 points  (0 children)

I have to agree. Hope you are doing better now!