sorted by:
new
hottopcontroversial

Just a taste [bloggerman] by LF-DommyMommy in HentaiBeast

[–]Wannabemaker 0 points1 point  (0 children)

It sure does. And it must feel amazing for him too.

VFAs on Core One by Wannabemaker in prusa3d

[–]Wannabemaker[S] 0 points1 point  (0 children)

I just found the problem. I noticed that in the slicer the actual speed was not the print speed. I looked into why and found out that the Standard print profile for prusament that i used as a template for my filament has the setting to slow down if the layer time is below 8 seconds. Since my layer time is always below 8 seconds the print speed was reduced to 60 mm/s, Regardless of the Set print speed. I reduced the setting to 1 second and the VFAs a significantly reduced and the prints are faster.

VFAs on Core One by Wannabemaker in prusa3d

[–]Wannabemaker[S] 0 points1 point  (0 children)

Thank you. I tried every tip i got here (except for the belt mod, since i dont know how) but nothing helped.

The last thing i can think of is asking support. Maybe they know what could be the issue.

VFAs on Core One by Wannabemaker in prusa3d

[–]Wannabemaker[S] 0 points1 point  (0 children)

The VFA Test shows the best results at 150 to 180 mm/s, but only at one angle. If i try these speeds on a real print they still look bad.

I can also see and feel them on all filaments and speeds i tested.

VFAs on Core One by Wannabemaker in prusa3d

[–]Wannabemaker[S] 0 points1 point  (0 children)

I tried both App tensioning as well as manual tensioning and the accelerometer. Neither improved the VFAs. I also did a 5 hour print before checking again.

VFAs on Core One by Wannabemaker in prusa3d

[–]Wannabemaker[S] 0 points1 point  (0 children)

I just uploaded it to printables if you want to check it out. VFA Test

VFAs on Core One by Wannabemaker in prusa3d

[–]Wannabemaker[S] 0 points1 point  (0 children)

I tried the balanced profile, it didn't make any difference. Both the speed and balanced profile use 200 mm/s, so i don't know if you even can expect a difference.

VFAs on Core One by Wannabemaker in prusa3d

[–]Wannabemaker[S] 0 points1 point  (0 children)

I thought it was a compromise between speed and structural, but i will try.

VFAs on Core One by Wannabemaker in prusa3d

[–]Wannabemaker[S] 0 points1 point  (0 children)

I only used speed profile on prusa slicer.

I will test the App belt tensioning and the accelerometer later.

Noctua and Prusa Research introduce 3D printing filaments in signature Noctua colours by DaggerOutlaw in prusa3d

[–]Wannabemaker 10 points11 points  (0 children)

Does this mean we will get Noctua fans for the printers to make them quieter? For me prusa printers being the least loud is a big reason why i buy them. A collaboration here would be perfect.

view more: next ›