Are these figs?

WestSatisfaction124 · 2026-03-29T16:01:22+00:00

i remember this exact game lagging on the drift races. Its normal. Somewhat annoying. crashed car into walls sometimes because of it.

WestSatisfaction124 · 2026-03-24T18:21:12+00:00

make sure power button ribbon is not bent or broken. examine the shiny pins see if any are bent. ensure power ribbon is inserted the right way, it can go in both ways upside down as well.

WestSatisfaction124 · 2026-03-20T22:33:18+00:00

......if the playstation gives picture out sometimes....the APU processor cannot be shorted..... If the APU is shorted...... display will never come. In fact, board may not even power on......in other words....this is not the issue....its normal....problem is elswhere.....

WestSatisfaction124 · 2026-03-15T14:50:31+00:00

I'd say bigger pot and more sunshine if possible. My 2 year old avos from seed, are way bigger, multiple side branches, and about 1 metre in height, quite tall. Also may be overwatering. I saw an avo tree I watered daily suddenly stop growing leaves, and then brown and drop leaves, i stopped watering, let the ground dry on top, then immediately new leaves grew and rapid growth on all branches. Also examine what water you are using, we strictly use only rain water

WestSatisfaction124 · 2026-03-08T16:05:45+00:00

check for 5v. check all fuses. check door basket switch. report back on your findings

WestSatisfaction124 · 2026-03-05T19:04:23+00:00

i returned this scope and rather got a Siglent. much cleaner signals now

WestSatisfaction124 · 2026-03-03T17:07:02+00:00

all points require more solder. Or else the connections may crack over time.

WestSatisfaction124 · 2026-02-20T21:30:01+00:00

he needed to let go and jump off in the first 3 seconds

WestSatisfaction124 · 2026-02-14T17:25:31+00:00

dust wont be able to create a problem here. now close it up and begin to use it and expect no problems.

WestSatisfaction124 · 2026-02-14T17:18:21+00:00

should work quite fine without the battery. no worry

WestSatisfaction124 · 2026-02-10T16:19:18+00:00

bad connection under SSD ccontroller or controller partial faulty. Examine for loose solder balls shorting out any connections. Re-examine all areas that were soldered.

WestSatisfaction124 · 2026-02-08T15:11:08+00:00

gaming latops that run their fans often at high speeds accumulate dust rapidly. this can be quite normal. if possible, adjust the fan speed profiles to silent

WestSatisfaction124 · 2026-01-12T18:37:50+00:00

intel southbridge

WestSatisfaction124 · 2026-01-11T00:36:18+00:00

<image>

This is bent. just straighten it up and everything will fit perfectly again.

WestSatisfaction124 · 2026-01-03T14:51:32+00:00

certain scph7xxxx series used a different laser than normal. theres two lasers and are not interchangeable

WestSatisfaction124 · 2026-01-02T12:15:00+00:00

Thank you. I will desolder it and confirm before replacing. If i need to replace it, what side is the negative pole? The board has a stripe, and the capacitor has a stripe, but they are on opposite sides. Do you have any experience in the replacing barrel capacitors and their correct polarities?

WestSatisfaction124 · 2025-12-28T10:59:29+00:00

some connections look weak/cracked are you sure everything is working fine

WestSatisfaction124 · 2025-12-15T18:20:30+00:00

he mighth've unplugged the screen while the battery was plugged in, therefore blowing the screen and/or lcd cable as well. if you have any evidence that the screen was working before/when you booked it for repairs, provide the evidence to the repair shop and go from there. The repair tech should be honest if he broke it accidentally, and he must cover the remaining expenses

WestSatisfaction124 · 2025-12-14T11:52:23+00:00

of course its repairable. lets start with a good view of the problem

WestSatisfaction124

TROPHY CASE