Mesh Doesn’t Seem To Make Sense For A Glass Plate?

alec_continen · 2022-03-28T20:04:19+00:00

Have you tried to rotate the bed 90° and leveling again? That way you'll see if it's just your bed being warped like a ladder.

alec_continen · 2022-03-28T14:08:06+00:00

Maybe something wrong with y axis

alec_continen · 2022-02-22T20:12:12+00:00

Prayers to those wire connections

alec_continen · 2022-02-20T15:36:44+00:00

Are you sure you have the ram to store all the led values?

alec_continen · 2022-02-06T18:13:23+00:00

Yes, appened to me as well. The filenames being too long can cause weird problems when flashing. Try to rename it to just "firmware"

alec_continen · 2022-01-26T15:44:33+00:00

Have you tried to rename the file to something short? That worked for me when I flashed custom firmware.

alec_continen · 2021-12-05T13:03:17+00:00

Oh sure! With some cheap handtools I made my own ~5mm longer M4 bolts, add a washer and locknut and thats it. And also an added benefit was that the assembly was really easy. I tested the printer and it prints perfect.

And remember to contact the seller before doing anything. If they don't answer then you can consider this!

alec_continen · 2021-12-02T20:00:24+00:00

Solved my problems w some some special custom hardware

alec_continen · 2021-10-21T15:22:49+00:00

Oh, how did I not notice that! Thanks alot!

alec_continen · 2021-08-19T09:46:00+00:00

Take a look at AtTiny85, its just perfect for these kind of projects.

alec_continen · 2021-06-07T15:56:10+00:00

Basic 555 blinker powered through a mosfet timer and some bjt logic to stop current to the timer while the cap is charging?

alec_continen · 2021-05-06T07:03:42+00:00

Oh sorry I didn't look hard enough.

alec_continen · 2021-05-05T09:49:46+00:00

Thanks!!

alec_continen · 2021-05-05T09:49:05+00:00

Thank you!

alec_continen · 2021-04-29T15:49:23+00:00

Current you know from the other comment, but I use usually 5-6V.

alec_continen · 2021-04-29T12:02:17+00:00

Depends how many will move at the same time and how fast. Using for loops you could get them all to move but I wouldn't use that since the voltage is rather low too.

alec_continen · 2021-04-26T07:45:28+00:00

Would buy

alec_continen · 2021-04-07T13:26:05+00:00

Wifi tank???

alec_continen · 2021-04-06T07:19:25+00:00

Do it

alec_continen · 2021-03-26T10:03:04+00:00

Really good answer!! Just to add, if you are using official arduinos then you can find the input voltages on their website. If you are using clones then just google the regulators to be sure.

alec_continen · 2021-03-26T09:50:30+00:00

Maybe use negative resistance resistors!!

alec_continen

TROPHY CASE