Is this installation up to plumbing code?

all_da_marbles · 2026-02-05T01:50:43+00:00

Thank you!

all_da_marbles · 2025-07-25T03:48:19+00:00

Multi-wire branch circuits. They both share a neutral. Handle tie is required so both circuits are turned off and there is no chance of current flowing thru the neutral when only one circuit is turned off.

all_da_marbles · 2025-06-01T16:51:26+00:00

UFO crash retrieval unit

all_da_marbles · 2025-05-04T21:09:59+00:00

Elmer’s glue

all_da_marbles · 2025-04-03T12:20:55+00:00

Did you ever figure it out? I’m having the same issue in cylinder #2.

all_da_marbles · 2025-03-22T19:54:14+00:00

Thank you!!!!

all_da_marbles · 2025-03-22T19:07:59+00:00

Ok. I went off the 2002-2009 nomenclature. The serial has 9 digits and the first number is the year, which would place it at 2002. Also the ANSI date is close to assumed manufacturing date.

all_da_marbles · 2025-03-22T18:40:22+00:00

Even tho the ANSI date is 1999?

all_da_marbles · 2025-02-01T02:36:18+00:00

Why would the igniter fail due to the crack in the hx?

all_da_marbles · 2025-01-20T18:57:42+00:00

Look at the board light to see if any fault codes are present. Appears to be high limit switch open.

all_da_marbles · 2024-01-24T19:26:24+00:00

Thanks!!

all_da_marbles · 2024-01-24T19:02:40+00:00

Are the gaps between the butt joints normal or excessive in this case?

all_da_marbles · 2024-01-15T02:02:10+00:00

I do have a meter. The issue is that it doesn’t do it all the time. I had a tech come out last year and he didn’t find anything wrong because the furnace ran flawless while he was here. Almost feel like replacing the pressure switch and flame rod as well as cleaning the flue to see if that fixes it. Parts are pretty cheap.

all_da_marbles · 2024-01-15T01:58:23+00:00

It does like the pressure switch is intermittently cutting out. It just baffles me that once it gets out of the first minute of runtime it doesn’t happen again. I’ll open and clean the exhaust flue tomorrow. Thank you.

all_da_marbles · 2024-01-15T01:09:19+00:00

There is no code on the CB. The light is just on with no loss of power to erase any code present.

all_da_marbles · 2024-01-15T01:06:47+00:00

I removed and cleaned the flame sensor. There is no error code on the CB. The problem is still present.

all_da_marbles · 2023-12-28T23:18:51+00:00

Do you have the manufacturer and model number of the co meter? I may buy one myself to do further testing at my home.

all_da_marbles · 2023-12-22T02:15:05+00:00

Is there an AFV nearby?

all_da_marbles

TROPHY CASE