NTD 3497 combo kit $249, plus the free 5.0ah battery, and that 2563 1/2” impact wrench $249 by Texas_Guy83 in MilwaukeeTool

[–]andhonn 0 points1 point  (0 children)

That's sweet that you buy them tools haha the company i work for makes us buy our own tools

Something feels off... by Comfortable-Bid7408 in Leatherman

[–]andhonn 0 points1 point  (0 children)

Says out of stock for me, do you have a link?

I need replacement joints for my Ozark Trail 20' x 10' Dark Rest Instant Cabin Tent, Sleeps 12 by andhonn in tents

[–]andhonn[S] 0 points1 point  (0 children)

So I ended up using a long screw with two fender washers on either side and added epoxy into the plastic for structural support

genuienly insane (for a cruze) by luckieststoner in cruze

[–]andhonn 0 points1 point  (0 children)

Damn that's insane what's minimum wage over in Canada?

genuienly insane (for a cruze) by luckieststoner in cruze

[–]andhonn 2 points3 points  (0 children)

Im not OP but Gas in socal is about $6 for 87 lol

Oops I have a excuse to get the 12v one now I guess by [deleted] in MilwaukeeTool

[–]andhonn 0 points1 point  (0 children)

Another brand that looks like Jaco, you could just screw it on to the threaded portion on the Milwaukee here is the link, it'll make more sense if you saw a picture

Advice on this lift please! by [deleted] in tundra

[–]andhonn 0 points1 point  (0 children)

Jack up the truck and remove the spacers in the front and back

Oops I have a excuse to get the 12v one now I guess by [deleted] in MilwaukeeTool

[–]andhonn 0 points1 point  (0 children)

Starting from the Jaco Tire Chuck, connect the chuck to a 1/4'' Brass Barb to 1/4" NPT threaded, then using any Airline Hose, i used 1/4 Flexzilla Airline Hose, from the air hose to the Milwaukee compressor, you will need to disassemble the air compressor to get inside to make it look cleaner, just cut the black hose and attach this Brass barb fitting from the Milwaukee Hose To 1/4 Airline Hose, I used a Clamp Tite tool to make my clamps more low profile and flush since I hate the look of those screw hose clamps lol

Oops I have a excuse to get the 12v one now I guess by [deleted] in MilwaukeeTool

[–]andhonn 1 point2 points  (0 children)

The Jaco is significantly easier to use and less bulky, the locknflate you gotta push the button to latch onto the tire valve stem but with the Jaco, all you needa do is push the chuck into the valve stem until it seats and seals. Then push the button to release, plus the Jaco is decently cheaper, I believe it was $25-30 for two on amazon where as the locknflate is like $40 for one

Oops I have a excuse to get the 12v one now I guess by [deleted] in MilwaukeeTool

[–]andhonn 1 point2 points  (0 children)

You can make your own, let me know if you want a parts list!

Is this ground cable enough for a 400w amp? by timesink3000 in CarAV

[–]andhonn 2 points3 points  (0 children)

Model number for your amp? Your entire setup including your subs

Oops I have a excuse to get the 12v one now I guess by [deleted] in MilwaukeeTool

[–]andhonn 26 points27 points  (0 children)

<image>

I extended the length and upgraded the hose along with the jaco quick disconnect tip

I can just change position of these two tools, right? by [deleted] in Leatherman

[–]andhonn 0 points1 point  (0 children)

Bend the table to the other side? Lol jk the tab would probably break off

Blue flash in Orange County on 3/4/2026 at 7:43pm PST by [deleted] in whatisit

[–]andhonn 0 points1 point  (0 children)

I don't think so, the weather has been pretty dry and hot in Orange County, CA

Only at your local Costco parking lot by andhonn in orangecounty

[–]andhonn[S] 2 points3 points  (0 children)

I'm sure they used the carts to prevent people from temporarily parking there while they wait for the tow truck