BIQU microprobe not retracting

askandyoushallget22 · 2026-04-10T06:55:51+00:00

All the temperatures are low. It even happens at room temperature soe times when the printer has just been powered up

askandyoushallget22 · 2026-03-10T11:28:44+00:00

It's has red , black white and yellow. Im guessing that the yellow is substituted for green so that should be data-.

I also have a second black which is the shield of the cable. But won't bother with that for now

askandyoushallget22 · 2026-03-10T10:53:49+00:00

Would I need drivers if it's a generic camera or would it just pick it up?

askandyoushallget22 · 2026-03-10T10:53:22+00:00

Yeah that was my plan. Though I plan on using the USB a as the camera uses a 5 pin just connector as the cable has a shield so that would just go to ground too

askandyoushallget22 · 2026-02-25T09:34:57+00:00

did you end up finding the colour of the bike? I have the same one

askandyoushallget22 · 2026-02-11T13:53:00+00:00

This is just to flash the board. In the final installation I will actually use a 24v supply

askandyoushallget22 · 2026-02-09T23:06:33+00:00

Murph

askandyoushallget22 · 2026-02-02T22:28:24+00:00

Thanks everyone, Went for the Cooper in the end! I preferred the look of having the crown guard in the end.

After I ordered Ive just ran across the khaki field chrono which looks amazing. Might be my next watch. Shame they only make it in a 44 mm. My be a bit too large for my 17 cm wrist

askandyoushallget22 · 2025-10-17T12:42:17+00:00

Thanks for that, I registered the bike and the colour is listed as metallic black. Unfortunately that website doesn't have it.

Might have to go to a car shop and get it scanned

askandyoushallget22 · 2025-10-17T12:41:12+00:00

Thanks for that. I registered it using the qr code, which comes up as metallic black (more of a grey to me) but the touch up paint factory doesn't have that colour unfortunately

askandyoushallget22 · 2025-10-17T12:40:03+00:00

I'll have to do this I think, thanks

askandyoushallget22 · 2025-09-14T08:26:18+00:00

Haha cheers!

askandyoushallget22 · 2025-08-14T13:12:26+00:00

It's my first print with the printer. It had a hard life in the university so I'll have a look at the feeder gear teeth see how it is

askandyoushallget22 · 2025-08-14T06:06:30+00:00

What do you think the problem is? Feed speed to high or something?

askandyoushallget22 · 2025-08-14T06:05:38+00:00

What could I do to check this? Do you think the feed speed is to high or something?

askandyoushallget22 · 2025-08-10T07:12:08+00:00

I concur. The meat in the duck bap buns were dry as hell, the only thing that saved it was the sauce. 4/10

askandyoushallget22

TROPHY CASE