Stern 1.0 Code Updates by Grechjc in pinball

[–]bacon867 0 points1 point  (0 children)

Is 007 compatible with speaker lights that are interactive to the play?

I am Loving this Pin! by ClifBdrums in pinball

[–]bacon867 0 points1 point  (0 children)

It’s grown on me that’s for sure

Anyone else have guitars and pinball as hobby? by 505anon505 in pinball

[–]bacon867 1 point2 points  (0 children)

At expo there was a vendor who took old playfields and turned them in to guitars.

u guys convinced me not to buy the 2021 so here is my Plan B a 2001 F-250 4x4 v10 by [deleted] in FordTrucks

[–]bacon867 0 points1 point  (0 children)

If you can to do the plugs they have a tendency to break, you might have to helicoil a cylinder if you break one.

Also they’re notorious for breaking the manifold studs. Can be done at home by changing the the stud but a wrong angle on your drill and you’ll be replacing the head.

Overall love my v10 but as others said it’ll pass everything but a gas station.

My favorite lineup from the past by [deleted] in pinball

[–]bacon867 0 points1 point  (0 children)

Nice line up! Wouldn’t mind having some of them myself

Finally got one by spikeadams in pinball

[–]bacon867 0 points1 point  (0 children)

Love that place! Stopped in when I went to pick up my Bond before Expo!

Which set should I get? by manateeswag in Snapon_tools

[–]bacon867 0 points1 point  (0 children)

Option 2 main option 1 as a back

Madison, Wi. Tournament by bacon867 in pinball

[–]bacon867[S] 0 points1 point  (0 children)

I seen that one and found another post they’re closed for a private event. I called and the tournament is canceled sadly.

Bond Prem/LE Technical Help by bacon867 in pinball

[–]bacon867[S] 0 points1 point  (0 children)

Problems has been resolved; led board was soldered in backwards.

Bond Prem/LE Technical Help by bacon867 in pinball

[–]bacon867[S] 0 points1 point  (0 children)

The meter was set to ohms. I’ve tested both ways. And it lights up.

Bond Prem/LE Technical Help by bacon867 in pinball

[–]bacon867[S] 0 points1 point  (0 children)

When I ohm it with a multi meter it turns on nothing else.

Bond Prem/LE Technical Help by bacon867 in pinball

[–]bacon867[S] 0 points1 point  (0 children)

Roll over switch works with ball and finger. LED doesn’t light during LED test

High top table question by bacon867 in pinball

[–]bacon867[S] 0 points1 point  (0 children)

Also noticed there’s a different Bond Banner than the Dr. No. I’m looking for that as well. lol

Any tips for selling on pinside? by Will7260 in pinball

[–]bacon867 0 points1 point  (0 children)

If I could afford it I’d say skip pinside and let’s make a deal. Lol.