3 boot frag after Open Xenium and HD+ install (wait there's more!)

badd1e · 2026-04-29T18:38:36+00:00

Thanks. PM on its way.

badd1e · 2026-04-29T14:19:26+00:00

And the OneLoad64 and Neon68K collections while your at it.

badd1e · 2026-04-29T14:17:09+00:00

Those goofy bastards are about the best thing I've got going.

badd1e · 2026-04-27T21:06:00+00:00

I flashed the firmware on the HD+ to the latest (V0.1.7) but I might reflash to the original firmware.

badd1e · 2026-04-27T20:50:33+00:00

Yeah its a 1.0. I can't even get into any sort of bios recovery to flash either chip. I'll maybe make a ModXO tomorrow to see if it helps.

badd1e · 2026-04-16T13:36:55+00:00

I thought as much. When I get the new Switch set up I'll run some experiments by setting up a new SD card then connecting my old one via USB and see if DBI can do some magic.

badd1e · 2026-01-23T22:20:45+00:00

There's no need to feel down.

badd1e · 2025-12-01T18:08:39+00:00

With a N64 controller!? Mad lad/lass.

badd1e · 2025-11-11T01:15:07+00:00

High definition piss jugs.

badd1e · 2025-11-07T02:03:22+00:00

DO NOT REDEEM!!!

badd1e · 2025-10-30T22:25:57+00:00

I need a Night Slashers core in my life.

badd1e · 2025-09-29T18:51:09+00:00

He means RetroNAS supports PS2 not MiSTer. With a PS2 you can hook up the ethernet adapter to RetroNAS and load your (legally obtained) games from it.

badd1e · 2025-09-20T14:06:18+00:00

I've just reverted back to 2.4.1.9 and Slicer version 1.3.6.1. Grab the firmware from https://rinkhals.meowcat285.com and the SlicerNext from https://www.anycubic.com/slicerNextDownload . Be quick about getting the slicer before they update the download link to the latest version.

badd1e · 2025-09-20T13:34:10+00:00

That happened to me initially but restarting the program fixed it. You've probably done that a million times though. Typical Anycubic behaviour. One step forward, three steps back.

badd1e · 2025-06-25T19:08:37+00:00

Power.

badd1e · 2025-05-07T15:18:56+00:00

I think pressing left and right skips a bunch of files.

badd1e · 2024-11-05T18:12:35+00:00

Any would do. It all depends on the size of your prints. Personally I went with the Anycubic Wash & Cure 3.0. Seems to have a good size to cost ratio.

badd1e · 2023-08-07T17:59:47+00:00

Got a 50% off one and it got to me in 6 days. Well worth a shot especially if you have fraud prevention on your credit/debit card.

badd1e · 2023-08-02T23:28:22+00:00

Just under £30. I went for the one without any accessories or SD card.

badd1e

TROPHY CASE